Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A ray of light in air strikes a glass plate (n=150) at an incidence angle of 50 degrees. Determine the angles of the reflected and refracted rays.
Interface TTL logic to 120 VAC lamp. In this part of the lab, you will interface lowpower solid state electronics to the "outside world" by switching the 120 VAC lamp on and off using the AND gate from the previous experiment.
The dielectric materials used in real capacitors are not perfect insulators. A resistance called a leakage resistance in parallel with the capacitance can model this imperfection. A 170-F capacitor is initially charged to 100 V
3. Which of the following is not an advantage of FETs over BJTs in RF amplifier usage. A) Their input impedance does not load down the Q of the circuit preceding the FET stage. B) The availability of dual gate FETs provides an isolated injection poin..
A flashlight battery with a voltage of 1.2 would be considered. During servicing, Ni-Cad batteries are normally overcharged to of the rated amp-hour capacity. What is done in an airplane in flight to mitigate this complication
Assuming that the door is relatively thin, the moment of inertia will be the same as that of a rod rotating about an axis at its end. If the mass of the door is 10 kg and its width is 1.5 m, find the angular acceleration of the door after applying..
A long narrow rod has an atomic density of 5*1028 m-3. Each atom has the polarizability of 10-40 F m2. Find the internal electric field when an axial field of 1 V/m is applied.
Design a circuit to add two 2-bit numbers using a 7483 4-bit adder. Use 2 switches on the designer to input 1 value and 2 other switches to input the other value. 1)The 7483 adds 2 4-bit values. What must be done with the unused inputs
The bit energy to one-sided noise density at a PCM receiver input is 30 dB. Referring to the figure above, determine the approximate detected S/N ratio (in dB) for 8-bit BPSK with a matched filter detector.
A 3-phase 230 V, 9 kVA, 0.9 PF (lagging) load is supplied by 10 kVA, 1330/230 V, 60 Hz three-phase transformer connected in Y-?. The equivalent impedance of transformer referred to the low-voltage side is 0.12 + j0.25.
This washing machine would have a fill cycle to one level, a 10 second wash cycle, a 10 second rinse cycle and then drain. Include a start button, low level switch, high level switch, an agitator motor, a fill valve and a drain valve.
The small identical conducting spheres have charges of2.0 x 10^-9C and - 0.5 x10^-9 Coulomb respectively. When they are placed 4 cm apart. what is the force between them If they are brought into contact and then separated by 4 cm
design an IIR high-pass filter using bilinear method in a system with sampling frequency of 100 Hz. The lower and higher cutoff frequencies are at 18 Hz and 35 Hz respectively. Pre-warp the cutoff frequencies.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd