Determine the amount of heat loss by the system

Assignment Help Civil Engineering
Reference no: EM13559270

1.The true azimuth of line ab is193 degrees 20'. the angle measured counterclockwise between line ab and another line ac is 205 degrees 10'.the true azimuth of line ac is?

2.Water flows in a circular pipe of diameter D at a depth y (< D). The pipe is laid on a constant slope of So and the Manning coefficient is n. At what depth does the maximum flow rate occur?

3.A closed rigid tank contains 2kg of saturated water vapor initially at temperature of 433K. Heat transfer occurs from the system and the pressure drops to 150kPa. Determine the amount of heat loss by the system.

Reference no: EM13559270

Questions Cloud

What is the change in its linear momentum : A superball of mass 60g is dropped from a height of 2m . Itrebounds to a height of 1.80m. WHat is the change in its linear momentum
How much power dissipated in each bulb : a 360 ohms and 576 ohms light bulbs are connected in series.What is the total resistance? 360 + 576 = 936 Ohms , How much power dissipated in each bulb
Determine the percentage of the flow which passes through : A pipe network in the form of a cube is made with twelve identical pipes. Each pipe forms an edge of the cube. If the entire inflow and outflow occurs at two adjacent corners, determine the percentage of the flow which passes through the pipe connect..
Is it possible to compute the magnitude of the load : A brass alloy has a yield strength of 280 MPa, a tensile strength of 390 MPa, and an elastic modulus of 105 GPa. A cylindrical specimen of this alloy 12.7 mm in diameter and 250 mm long is stressed in tension and found to elongate
Determine the amount of heat loss by the system : Water flows in a circular pipe of diameter D at a depth y (
Find the temperature of the air after the compression : In a diesel engine, the piston compresses air at 301 K to a volume that is 0.0621 of the original volume, What is the temperature of the air after the compression
Determine the uniform depth in the channel : A clean-earth channel, for which n=0.020, is 6m wide and lies on a slope of 0.005236. Water flows at 30m3/s through the channel and enters a reservoir. The water depth in the channel, just before the entry to reservoir, is 3m.
Determine the speed of the cubic block down the plane when : Determine the speed of the cubic block down the plane when in equilibrium.Hence determine the total force required to pull the cubic block up the plane at the same speed.
Simplify the shape of the base and the 4 legs and estimate : The Statfjord B drilling platform, was built in Norway and towed 370km in 5 days to its present site in the North Sea in August 1981. It is the heaviest object ever moved by man

Reviews

Write a Review

Civil Engineering Questions & Answers

  How many cubic yards of soil must be excavated from pit

The soil will be excavated from the borrow pit, moistened to increase the water content to 13.5% (assume i will not change the volume of solid mass) and then compacted to a final dry unit weight of 118 pcf.

  Find the moment of inertia around the x-axis and y-axis

Using a unit analysis, calculate the value of the K term in the rational method equation (Q = K C I A) in English and SI respectively.

  Determine the r-134a exit temperature in the enthalpy

At compressor exit, the specific entropy is the same as that at the inlet, and the pressure is 60 psia. Determine the R-134a exit temperature and the change in the enthalpy of R134a.

  Determine elevation and stationing of high point pvc and pvt

a 520 ft long equal tangent crest vertical curve connects tangents that intersect at station 340 00 and elevation 1325 ft the initial grade is if 4 and the final grade is 2.5.

  How many cubic yards of aggregate must be ordered for a road

How many cubic yards of aggregate must be ordered for a road base 16 inches thick and 2000 feet long with a top width of 30 ft, if the side slopes are one on one, or 45 degree?

  Develop an equation for a safe minimum design radius r

The speed limit for a highway is given as "V" in mph. The highway super elevation is given as "e" in ft/ft. The friction between tires and wet pavement is given as "f".

  What is the mixed liquor suspended solids concentration

An activated sludge system treats 1500 m3/day of raw wastewater with a BOD of 250 mg/L. The reactor volume is 375 m3. The kinetic parameters were determined to be: x = 3 day-1, Y = 0.55 kg SS/kg cells, and Ks = 150 mg/L.

  Determine storage 1 hr later if average rates are given

The storage in a reach of river is 20,000 m^3 at a given time. Determine the storage 1 hr later if the average rates of in flow and out flow during the hour are 20 and 18 m^3/s, respectively

  What should be the design capacity of the distribution pipes

A water supply system is being designed to serve a population of 200,000 people with an average per-capita demand of 600L/Person-day (peak demand factor is 1.8) and a needed fire flow of 28,000 L/min.

  Determine what is the stationing of the pt

A crest vertical curve and a horizontal curve on the same highway have the same design speed. The equal-tangent vertical curve connects a +3% initial grade with a +1% final grade and has a PVC at 101+78 and a PVT at 106+72

  Determine the perpendicular distance d from the line

A line passes through the points (22 m, 19 m) and (-2 m,-5 m). determine the perpendicular distance d from the line to the origin O of the system of coordinates.

  Determine the maximum height the projectile will reach

A projectile is fired up into the air at a speed of 161 m/s at an angle of 64° relative to the horizontal. Determine the maximum height the projectile will reach.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd