Determine normal stresses induced in steel and in concrete

Reference no: EM13320882

The concrete post (Ec=3.6*10^6 psi and Ac= 5.5*10^-6/degrees F) is reinforced with six steel bars. each of 7/8-in diameter (Es=29*10^6 psi and As=6.5*10-6/ degrees F). Determine the normal stresses induced in the steel and in the concretee by a temperature rise of 64 degreesF.

Reference no: EM13320882

Questions Cloud

Find the steady state concentration for the air in the box : Consider the air over a city to be a box 100km on a side that reaches up to an altitude of 1.0 km. The air is blowing into the box along one of its sides with a speed of 4 m/s.

What is the rms voltage for the source : Suppose V max = 120 V for an alternating current power source. What is the rms voltage for the source

Write the general equation of magnetic force : Write the general equation of Magnetic force on a current carrying wire of length L in a magnetic field B such that the magnetic field and the current direction make an angle different than 0^0 and 180^0

Determine the dead uniform load in kips per linear foot : A wide flange steel beam supports a permanent concrete masonry wall, floor slab; architectural finishes mechanical and electrical systems. Determine the dead uniform load in kips per linear foot acting on the beam.

Determine normal stresses induced in steel and in concrete : The concrete post (Ec=3.6*10^6 psi and Ac= 5.5*10^-6/degrees F) is reinforced with six steel bars. each of 7/8-in diameter (Es=29*10^6 psi and As=6.5*10-6/ degrees F).

Find the maximum emf induced in the coil : In a model AC generator, a 503 turn rectangular coil 5.0 cm by 21 cm rotates at 120 rev/min in a uniform magnetic field of 0.59 T. What is the maximum emf induced in the coil

What is the ph of a buffer : What is the ph of a buffer that results when .40 mol nahco2 is mixed with 100 ml of 2.0 m hcl and diluted with water to 250 ml

Find the total work done by the gas in one cycle : Two moles of an ideal monoatomic gas undergo a cyclic process starting from state A at a vol. of 1L and a pressure of 2 atm. Find the total work done by the gas in one cycle

What is the position of the block : A 2.00 kg. frictionless block is attached to an ideal spring with force constant 300 n/m. At t=0 the block has velocity -4.0 m/s, what is the position of the block when its speed is 2.5 m/s

User Account

All Pages