Determine minimum resale price needed to make the challenger

Assignment Help Civil Engineering
Reference no: EM13312008

A lumber company that cuts fine woods for cabinetry is evaluating if it should retain the current bleaching system or replace it with the new one. The relevant costs of each system are known or estimated.

Current System

First Cost seven years ago, $ 450,000

Remaining Life, years 5

Current market value, $ 50,000

Annual Operating Costs, $/year 160,000

New System

First Cost, $ 700,000
Remaining Life, years 10
Annual Operating Costs, $/year 150,000
Future Salvage, $ 50,000

Use an interest rate of 10% per year to

a) Perform the replacement analysis and

b) Determine the minimum resale price needed to make the challenger replacement choice now.

Reference no: EM13312008

Questions Cloud

Explain what is the empirical formula of the phosphorus : A 46.2mg sample of phosphorus reacts with selenium to form 135mg of the compound. What is the empirical formula of the phosphorus selenide
How to select the lightest steel wide flange section : The span length is 32 feet. Total deflection is not to exceed span/240. Select the lightest (economical) steel wide flange section (W shape) with a yield stress of 50 ksi. Assume the beam weight to be 200 PLF
What is the maximum safe initial angle : Walking by a pond, you find a rope attached to a tree limb 6.0 m off the ground. You decide to use the rope to swing out over the pond. What is the maximum safe initial angle between the rope and the vertical so that it will not break during the swi..
Explain the equilibrium constant has been measured : When white phosphorous (P4) is heated above 1100 K, the following equilibrium is observed in the gas phase P4 ? 2P2 b. The equilibrium constant has been measured as a function of temperature for this reaction
Determine minimum resale price needed to make the challenger : A lumber company that cuts fine woods for cabinetry is evaluating if it should retain the current bleaching system or replace it with the new one. The relevant costs of each system are known or estimated.
What is the degrees north of west : two hockey players strike a puck of mass of .164kg, one from westward force of 1.10 x 10^3 Newtons, what is the degrees north of west
Define acetic acid when pure, has a freezing point : Acetic acid when pure, has a freezing point of 16.0 Celsius; Liquid acetic acid has a heat capacity of 1.96J/g*C. A 25.0 g piece of solid acetic acid at 16.0C is placed into an insulated container containing 50.0g of liquid acetic acid at 50.0C.
Define what is the experimental formula for the hydrate : A sample of unknown hydrate of FeCl3 weighs 8.693g. After heating the sample to constant mass, the remaining anhydrous salt weighs 5.216g. What is the experimental formula for the hydrate
The final stage in the project life cycle : Everything in this life has to come to end, that the closure process is the final stage in the project life cycle, it's the time to gather our efforts result, that we have to carefully dealing with that stage in order collect the maximum benefits fro..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the specific gravity of the liquid of an object

An object which has a volume of 0.18 m^3 requires a force of 265 N to keep it immersed in water. If a force of 157 N is required to keep it immersed in another liquid, find the specific gravity of the liquid

  What must drivers eye height be in van for students claim

A civil engineering student contends that 60 mph is safe in a van because of the higher drivers line of site. If all other design inputs are standard, what must the drivers eye height be in the van for the students claim to be valid

  Calculate vapor pressure-air pressure and relative humidity

Calculate the vapor pressure, air pressure, relative humidity, and air density at elevation 1500 m if air temperature is 25 degrees C and dew point temperature is 20 degrees C and the lapse rate is 9 degrees C/km

  Find outlet volumetric flow of toluene from the process

Saturated steam (at 20 bar) is used to heat up a toluene stream from 40oC, 1 bar to 150oC, 1 bar in a heat exchanger. The toluene stream is flowing at a rate of 100 kg/min. Steam leaves the heat exchanger as a saturated liquid at 20 bar.

  What is the cumulative depreciation through the end of year

Under the 200% DB depreciation, what is the cumulative depreciation through the end of year four? The useful life of the mixing tank is 9.5 years.

  Determine how much heat had to be transferred to the vessel

Alkaloids are chemical compounds containing nitrogen that can be produced by plant cells. In an experiment, an insulated closed vessel 1.673 m3 in volume was injected with a dilute water solution containing two alkaloids: ajmalicine and serpentine..

  What is the probability that a random sample

What is the probability that a random sample of 20 time intervals between eruptions has a mean longer than 95 minutes?

  How to calculate the asphalt content by weight of mix

The VMA of a mixture is 15.0% and the air voids are 4.0%.If the aggregate has a specific gravity (bulk dry) of 2.700 g/cm3 and percent binder absorbed (by the mass of aggregate) is 0.5%, calculate the asphalt content by weight of mix.

  Of what industrial use are jominy hardenability curves

(a) Define the hardenability of a steel. (b) Define the hardness of a steel. (c) Describe the Jominy hardenability test. (d) Explain how the data for the plotting of the Jominy curve are obtained and how the curve is constructed.

  Determine maximum normal stress in each of links be and cf

Rigid members ABC and DEF are joined with steel links BE and CF using 25mm pins. The links are made of 25mm thick 50mm wide plates and are single shear. Determine the maximum normal stress in each of links BE and CF

  Determine what is the depth of flow in the case of channel

Water is flowing in a trapezoidal channel with 10 ft bottom width and 2H/IV side slopes. The channel is running on a slope of 0.00778 ft/ft and the flow exerts a shear stress of 1.5 lbs/ft2 on the channel bed. What is the depth of flow in this cas..

  What proportion of the true stress is the applied stress

A 10cm long cylindrical rod of steel is elongated to become 12.1cm long by the application of a force of 10kN. 1- What is the ration of initial diameter to final diameter, assuming no net volume change

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd