Determine minimum required bandwidth and baud rate

Assignment Help Electrical Engineering

Reference no: EM13247008

For a 128-PSK modulator with an input data rate equal to 56 Mbps and a carrier frequency of 100 MHz, determine (a) minimum required bandwidth and (b) baud rate.

Reference no: EM13247008

Questions Cloud

Find the potential of the plate on the left : Two infinite, parallel, uniformly charged plates with charge densities +sigma and +3sigma are separated by a distance L, what is the potential of the plate on the left

Find the total electric potential energy of this model : A useful model of a water molecule is sketched in the figure below, with point charges of 5.2 10-20 C at the H sites, What is the total electric potential energy of this model of a water molecule

Determine the weight of the astronaut : an astronaut weighs 1000N on the surface of the earth(radius = 6.38*10^6m) what is the weight of the astronaut at the elevation of 620 km above the earth's surface

Develop prediction interval and confidence interval : Develop prediction interval and confidence interval for y for the value of x you select. Interpret both intervals as they relate to y.

Determine minimum required bandwidth and baud rate : For a 128-PSK modulator with an input data rate equal to 56 Mbps and a carrier frequency of 100 MHz, determine (a) minimum required bandwidth and (b) baud rate.

Determine the value required for any pre-scaling : A PWM is used in 8-bit mode to produce a signal with a 1 msec period and 60% duty cycle. Determine the value required for any pre-scaling, and the values for the period, and duty cycle registers. The E-clock is 24 MHz.

Which is preferred if the target lifetime of the system : (Probability of negative lifetime is negligible) Lifetime of chip 2 is also a Gaussian RV with mean 22,000 and standard deviation 1000 hours. Which is preferred if the target lifetime of the system is (i) 20,000 hours and (ii) 24,000 hours

Express h in standard form for drawing a bode plot : Plot the Bode straight-line approximation phase plot (i.e., f(f) vs. f) for the transfer function over the range f = 10 rad/s to f = 100 krad/s using the 4-cycle semi-log graph paper provided. Label all slopes in degrees/dec and all levels in degr..

Calculate ni and the concentration of electrons and holes : An unknown semiconductor has Eg = 1.1 eV and Nc = Nv. It is doped with 10^15 cm^-3 donors where the donor level is 0.2 eV below Ec. Given that Ef is 0.25 eV below Ec, calculate ni and the concentration of electrons and holes in the semiconductor a..

User Account

All Pages