Determine mean u and unknown standard deviation sigma

Assignment Help Electrical Engineering
Reference no: EM13253594

A random variable X is normally distributed with unknown mean u and unknown standard deviation sigma. Find u and sigma if it is known that the probability X is less than 10 is 0.6950 and the probability that exceeds 6 is 0.7939.

Reference no: EM13253594

Questions Cloud

How to illustrate 6-pole stator winding of an ac machine : Use computer graphics/ or by hand to illustrate 6-pole stator winding of an AC machine. For wt = 0 and wt = 180o show the phasor diagram of phase currents, polarity of currents in individual conductors, and the flux paths.
What is the density of free electrons in the metal : A metallic wire has a diameter of 4.12 mm. When the current in the wire is 8.00 A, the drift velocity is 5.40 x 10^-5 m/s. What is the density of free electrons in the metal
Construct frequency distribution of demand during lead time : From the results of the simulation, construct a frequency distribution of demand during lead time.
How many conduction electrons in given gold wire : How many conduction electrons are there in a 3.50 mm diameter gold wire that is 50.0 cm long
Determine mean u and unknown standard deviation sigma : A random variable X is normally distributed with unknown mean u and unknown standard deviation sigma. Find u and sigma if it is known that the probability X is less than 10 is 0.6950 and the probability that exceeds 6 is 0.7..
Compute the magnetic flux through each turn : A 43.5 mA current is carried by auniformly wound air-core solenoid with 460 turns, a 17.0 mmdiameter, and 11.0cm length. Compute the magnetic flux through each turn
Explain what is the concentration of water vapor : Water Vapor Will react reversibly with methane (CH4) to produce carbon monoxide and hydrogen gas. The equilibrium, with a Kc=0.26, is established at 927 degrees C, in a 0.32L flask which contains 0.26 mol CO, 0.091 mol H2, and 0.041 mol CH4. What ..
Formulate a binary program to model : Sandra likes Bob about as much as Bill but likes them both about ve times as Ben. Formulate a binary program to model how the couples should pair up so that in the aggregate the girls are as happy as possible.
Explain what is the major purpose of doing distillations : What is the major purpose of doing distillations in organic chemistry. What is the secondary purpose

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Why colorado should or should not shut down its coal power

How does this cost compare with the current cost of new coal figured generation at 3.5¢/kWh? Write a brief (400 words or less) argument on why Colorado should or should not shut down its coal power plants and replace them with wind farms?

  Find the swr on the line and the reflection coefficient

A lossless transmission line of electrical length l = 0.3? is terminated with a complex load impedance . Find the reflection coefficient at the load, the SWR on the line, the reflection coefficient at the input of the line

  How can be use a nand gate to make a not gate

Interface TTL logic to 120 VAC lamp. In this part of the lab, you will interface lowpower solid state electronics to the "outside world" by switching the 120 VAC lamp on and off using the AND gate from the previous experiment.

  Explain difference in registered mode and combinational mode

A GAL is different from a PAL because A GAL has more inputs and outputs; A GAL is implemented with a different technology; A GAL can replace several different PAL's; A GAL can be reprogrammed and a PAL cannot

  Determine the theoretical minimum sampling rate

A baseband signal has frequency components from 5 kHz to 15 kHz. Determine (a) the theoretical minimum sampling rate and (b) the maximum time interval between successive samples.

  What is the gain of the filter at the cutoff frequency

(a) Design a high-pass filter with a cutoff frequency of 40 kHz. Use 0.01 uF capacitor and an appropriate resistor. B) Sketch and label the circuit. C) What is the gain of the filter at the cutoff frequency Give your answer both as ratio (Vout/Vin..

  What are the theoretical resolution and depth-of-focus

The required exposure energy for a positive photoresist is 140 mJ/cm2 and for a negative photoresist is 9 mJ/cm2. Assuming negligible times for loading and unloading wafers, compare the wafer throughput for positive photoresist and negative photor..

  Use the magnetization curve

Determine the battery voltage required to obtain a flux density of 1.2 T in the air gap. Use the magnetization curve.

  Explain what bit pattern

What bit pattern (after you remove the beginning and ending flags and any stuffed bits) will the receiver pass on for higher level processing?

  What resistance must be connected in series with heater rate

What resistance must be connected in series with a heater rated at 150mA with hot resistance of 320 ohm in order to operate it safely from a 117-V source. What power rating must this resistor have

  What is the diode current with the load connected

pecify the value for R. What is the diode current with the load connected What is the increase resulting in the output votage when the load is disconnected What change results if the load resistance is reduced to 100ohms? To 75ohms To 50ohms

  Explain saturated and unsaturated synchronous reactance

Saturated and unsaturated synchronous reactance, The following readings are taken from the results of an open- and a short-circuit test on a 9375-kVA three-phase Y-connected

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd