Determine max shearing stress and coexisting normal stress

Assignment Help Civil Engineering
Reference no: EM13323347

A 40 mm diameter solid brass shaft in a marine vessel is subjected to a simultaneous torsion of T=250 N.m and axial thrust of P=25kN.

(a) Show the combined state of stress on the surface element of the shaft.

(b) Draw a Mohr's circle for the state of stress shown in part(a).

(c) Determine the magnitude and direction of the principal stresses and show these on a correctly oriented element.

(d) Determine the maximum shearing stress and any coexisting normal stress on the element and show these on a correctly oriented element.

Reference no: EM13323347

Questions Cloud

Determine immediately after release angular acceleration : Assuming that the friction force between end A and the surface is large enough to prevent sliding, determine immediately after release (a) the angular acceleration of the rod, (b) the normal reaction at A, (c) the friction force at A
At which scattering angle is this wavelength observed : X rays with intial wavelegnth 6.75*10^-2nm undergo compton scattering, At which scattering angle is this wavelength observed
Explain the ir spectrum and n-butyl : Indicate the approximate location (cm-1) in the IR Spectrum where you would expect to see one or two absorptions that distinguish n-butyl, sec-butyl, and isobutyl from each other.
How far apart are the trains : An eastbound subway train accelerates from rest at 1.22 m/s2 along a straight track. How far apart are the trains when the eastbound subway train is traveling at the same speed as the westbound train
Determine max shearing stress and coexisting normal stress : A 40 mm diameter solid brass shaft in a marine vessel is subjected to a simultaneous torsion of T=250 N.m and axial thrust of P=25kN. Show the combined state of stress on the surface element of the shaft.
What advantages and disadvantages are to implementation : Do you foresee any technical difficulties in deploying this architecture? What advantages and disadvantages are there to this implementation?
Explain what mass in g of iron is needed to evolve : What mass (in g) of iron is needed to evolve 730.5 kJ of heat under standard conditions as it forms iron(III) oxide
Use an array to assign random numbers to the digits : Output the random digits to the screen, input the response from the user, and output whether or not the user's response correctly matches the PIN number.
Explain the sum of the stoichiometric coefficients : What is the sum of the stoichiometric coefficients the formation reaction for methanol (CH3OH). Enter any fraction as a decimal.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the horsepower dissipated in the jump

water flows at a velocity of 25 ft/s at a depth in a rectangular channel 16 feet wide. Determine the downstream depth necessary to form a hydraulic jump, the head loss through the jump and the horsepower dissipated in the jump.

  How to use the bisection method on the van der waals

how to use the bisection method on the van der waals equation Problem 1 (15 Points) The van der Waals equation gives a relationship between the pressure P (in atm.), volume V (in L), and temperature T (in K) for a real gas

  Find range of values for probability of succeful takeovers

The current price of a company stock is $20.The company is a takeover target.If the takeover is successful.the company's stock price will increase to $30.If the takeover is unsuccessful.the stock price will drop to $12.

  Determine the velocity of the 30 kg block a from rest

determine the velocity of the 30 kg block A if two block are released from rest and the 20 kg block B moves 0.6 m up the incline. the coefficient of kinetic friction between both blocks and the inclined plane is 0.10

  Determine the density in si unit of brass

The specific weight (wt./Vol.) of brass is 520 lb/ft^3. Determine its density (mass/vol.) in SI units. Use an appropriate prefix.

  Determine the required are of concrete for the thrust block

Given that the max shear strength of the the concrete shore is 10 kPa and the engineer requires a F.S. of 2.5, find the required are of concrete for the thrust block.

  Calculate the location of the effective depth on both sides

beam is 24 inch deep, the steel stirrup used is number 4,a 1 1/2 inch. concrete cover on both sides. Sketch how you will place the bars and calculate the location of the effective depth.

  Determine distance the officer traveled before overtaking

The officer believes the driver is intoxicated and begins accelerating uniformly to 50 mi/h in 8 seconds and maintains a constant velocity of 60 mi/hr, overtakes the motorist 42 seconds after he passed the officer.

  Which communitys transportation is more sustainable

Imagine two small towns of 1,000 people: Blacktop and Parktown. In the urban sprawl that is Blacktop, all the residents own fuel-efficient cars (15 km/liter) and travel an average of 20,000 km per year.

  Concentration and precipitate

AGNO 3 is added to a solution containing 0.001 mol Cl - amd 0.001 mol Br- per liter.What are the concentrations of Cl - and Br- remaining when AgCl just begins to precipitate?

  Determine the internal shear force and moment in the jib

The jib crane supports a load of 750 lb from the trolley which rides on the top of the jib. The members of the crane are pinned together at B, E, and F and supported by a short link BH.

  In which circumstance are multiple copies of unicast frame

1. In which circumstance are multiple copies of the same unicast frame likely to be transmitted in a switched LAN. 2.If you want to disable STP on a port connected to a server, which command would you use

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd