Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Slots in the broad wall of a rectangular waveguide scatter power symmetrically, so that they can be modeled as a shunt admittance,Y, in a transmission line. Consider the waveguide structure below, with four equally space slots .68 lambda apart, where lamda is the wavelenght in the waveguide. slots 1 and 4 have normalized admittances y1/y0=y4/y0=.35 while slots 2 and 3 have normalized admittance y2/y0=y3/y0=.65 assume that there is zero electrical lenght between slot 1 and the absorber (match load).
draw a transmission line model for this device.
using smith chart determine the input admittance Yin and the SWR looking into the waveguide from the left at slot 4.
a sinusoidal voltage has a peak value of 15V, a frequency of 500Hz, and crosses zero with a positive slope at t=0.1 ms. write an expression for the voltage using a cosine function in terms of t and constant pi.
If it takes 1 sec to rotate 45 degrees after starting from rest, how long in seconds would it take to instead rotate 81 degrees after starting from rest under the same constant angular acceleration.
The boom AC is supported at A by a ball and socket joint and by two cables BDC and CE. Cable BDC is continuous and passes over a pulley at D. Calculate the tension in the cables and the x,y,z components of the reaction at A if the crate has a weig..
An IPv4 datagram has arrived with the following information in the header (in hexadecimal): Ox45 00 00 54 00 03 58 50 20 06 00 00 7C 4E 03 02 B4 OE OF 02 a. Is the packet corrupted b. Are there any options
Consider a thin ring of radius a with uniform charge density and total charge Q. The ring is cut in half across the diameter and the two halves superimposed to double the effective charge density.
Design a filter for a biomedical instrument to eliminate DC (f = 0), 500 Hz tone, and its corresponding harmonics. The system sampling rate is 2,000 Hz. Place all the required poles at the origin to obtain a FIR filter.
A 2 farad capacitor is charged up to 400v by a dc power supply. How long in seconds would it take to discharge the capacitor to a safe stored energy level of 1 joule using a 1k ohm high wattage resistor bank.
If the telephone instrument has a resistance of 200 ohms when off hook and represents an open circuit when on hook calculate the combined resistance of the local loop and the power source at the central office.
A particular inverting amplifier with nominal gain of -100 V/V uses an imperfect op amp in conjunction with 100-k-ohm and 10-M-ohm resistors. The output voltage is found to be +9.31 V when measured with the input open and +9.09 V with the input groun..
Why is the input voltage into the diode in a full-wave rectifier not smooth but the input voltage into the diode in a half-wave rectifier smooth, graphically speaking
encounter a sequence of birds while walking in the park. The birds can either be blue (B) or red (R). We let X be the random variable corresponding to the number of birds we encounter until seeing the first blue one.
Design a sequencer with an enabler with 3 outputs that when enabled follows a successive clock sequence of 000,000,011,011,110,110,010,011 when the last step is reached the sequence returns to the beginning.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd