Determine how many seconds does it take the arm

Assignment Help Electrical Engineering
Reference no: EM13287745

a) using the values of resistance for arm (400 ohm), leg (200), andtrunk(50), calculate the power dissipated in the arm, leg, andtrunk.

b) the specific heat of water is 4.18x10^3 J/kg(deg)C, so a mass ofwater M (in kilograms) heated by a power P (watts) undergoes a risein temp. at a rate given by:

dT/dt = (2.39x10^-4 P)/(M) degrees C/s

assuming that the mass of an arm is 4kg, the mass of a leg is 10kg,trunk 25kg, and that the human body is mostly water, how many seconds does it take the arm, leg, trunk to rise the 5 deg. C that endangers living tissue?

c) how do the values you computed in b compare with the few minutesit takes for oxygen starvation to injure the brain?

Reference no: EM13287745

Questions Cloud

What is the birds average acceleration : A migrating bird is initially flying south at 10 m/s. To avoid hitting a high-rise building, What is the bird's average acceleration during this 2 s interval
Core functions of public health-institute of medicine : Describe the Core Functions of public health as defined by the Institute of Medicine (IOM). Select one of the key federal health agencies under the Department of Health and Human Services. Describe the role of the agency and what particular function ..
What is the tension in each cable attached to its ends : The steel I-beam in the drawing has a weight of 1.50 × 103 N and is being lifted at a constant velocity. What is the tension in each cable attached to its ends
Explain an absorption measurement of this asa solution : An absorption measurement of this ASA solution at 275 nm in a UV-vis spectrometer with a 1.00 cm cell was 0.78. The solvent had an absorbance of 0.01 at 275 nm. Measurement of a 4.05x10-4 M ASA standard solution at 275 nm was 0.579.
Determine how many seconds does it take the arm : the specific heat of water is 4.18x10^3 J/kg(deg)C, so a mass ofwater M (in kilograms) heated by a power P (watts) undergoes a risein temp. at a rate given by: dT/dt = (2.39x10^-4 P)/(M) degrees C/s assuming that the mass of an arm is 4kg, the mass..
How long will the ball remain in the air : A tennis ball is hit with a vertical speed of 30 m/s and a horizontal speed of 25 m/s. How long will the ball remain in the air
How to calculate the molar mass of the acid : A 2.476 g sample of a monoprotic acid was dissolved in wate. it took 21.36 mL of a 0.1577 M NaOH solution to neutralize the acid. calculate the molar mass of the acid.
What is the bond current market price : Callaghan Motors' bonds have 22 years remaining to maturity. Interest is paid annually; they have a $1,000 par value; the coupon interest rate is 6%; and the yield to maturity is 5%. What is the bond's current market price? Round your answer to tw..
What is the yield on 2-year treasury securities : What is the yield on 2-year Treasury securities? Round your answer to two decimal places.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine value of sampling period ts according the info

Supposed that the signal y(t) is low -pass filtered. The magnitud od the low pass filter is unity and the cut off frequency is Rz= 5000*pi rad/sec. Determine the value of the sampling period Ts according to the given information.

  Does the sum of the resistor voltage drops satisfy kvl

V1(18V) R1(1k) R2 (1.5k) R3 (2k)How does the ratio V2 V1 compare to the raioR2 R1?How does the ratio V3 V1 compare to the raioR3 R1 Add the measured voltage V1 V2 and V3 How does this value compare to the value Vt

  What is the allowable signal swing at the collector

Using a 3-V power supply, design a version of the circuit of fig 6.62 from the book. to provide a dc emitter current of 0.5 mA and to allow a +-1-V signal swing at the collector. The BJT has a nominal B=100. Use standard 5 % resistor values

  Calculate the minority-carrier hole concentration at edge

Consider a Si p-n junction with n-type doping concentration of 10^16 cm^-3. This junction is forward bias with V=0.8 V at 300 °K. Calculate the minority-carrier hole concentration at the edge of the space charge region.

  What is minimum clock period required for state machine

For a state machine, suppose the propagation and contamination delays of the next state circuit are 20nsecs and 5nsec, respectively. For the registers to store the current state, the propagation delay, set-up time, and hold time are 4 nsec, 2nsec,..

  What is the combined gain-loss of the two cascaded blocks

An amplifier has a gain of 10 and follow a bandpass filter filter where the loss in the in the center of the bandpass is 0.05. What is the combined gain/loss of the two cascaded blocks at the center frequency of the filter

  Determine what value of c will be needed to produce wo

a 20 mH inductor with an internal resistance of 20 ohms is connected in series with a capacitor and a voltage source with a thevenin resistance of 60 ohms. a. what value of C will be needed to produce Wo = 6 krad/s

  Design a non-uniform linear array to have the pattern

A 3-element uniform linear array with inter-element spacing of λ/2 is operated as a broadside array ,find the directions of null radiation , find the direction and the relative level of the side lobe .

  Determine the value of the drain current when vsg

A p-channel MOSFET with VTP = -0.5 V has a drain current of 0.5 mA when VSG = 2.08 V and VSD = 5 V. Determine the value of the drain current when VSG= 3 V and VSD= 4 V

  Find how much power is dissipated by the transistor

at room temp a power transistor has beta of 160 and it is used in a DC dimmer circuit to control a 24 volt 120 watt lamp the lamp power supply is 48 volts dc and it can deliver a maximum of 21 amperes of current

  Find the carrier and intelligence frequency fm transmitter

An FM transmitter delivers to a 75 ohm antenna a signal voltage of V(t) = 1000 sin ( 109t + 4 sin 104t ) Determine: (a) Carrier frequency (b) Intelligence frequency (c) Modulation index (d) Total power in FM signal (e) Carrier power (f) Power in e..

  Find minority carrier concentration at emitter-base junction

A Si p-n-p transistor has impurity concentrations of 5´1018, 2´1017, and 1016 cm-3 in the emitter, base, and collector, respectively. The base width is 1.0mm, and the device cross-sectional area is 0.2 mm2.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd