Determine how many moles of hclo4 are in 1 l

Assignment Help Civil Engineering
Reference no: EM13315433

The density of 70.5 wt% aqueous perchloric acid is 1.67 g/mL. a. How many grams of solution are in 1.000 L? b. How many grams of HClO4 are in 1.000 L? c. How many moles of HClO4 are in 1.000 L?

Reference no: EM13315433

Questions Cloud

What resistance should the wire have : The wire in a 150 W aquarium heater has a diameter of 0.12 mm and is made of iron, What resistance should the wire have while the heater is operating
Determine the final equilibrium temperature in k : The partition is free to move and allows conduction from one gas to the other without energy storage in the partition itself. The air and carbon dioxide each behave as ideal gases. Determine the final equilibrium temperature
What will be the current amplitude at this frequency : You have a 208%u2212%u03A9 resistor, a 0.400%u2212Hinductor, a 4.91%u2212%u03BCF capacitor, What will be the current amplitude at this frequency
What is the cost of heating the water : Water has a specific heat capacity of 4186 J/kg C. A tank contains 500 kg of water at 10 C. what is the cost of heating the water
Determine how many moles of hclo4 are in 1 l : The density of 70.5 wt% aqueous perchloric acid is 1.67 g/mL. a. How many grams of solution are in 1.000 L b. How many grams of HClO4 are in 1.000 L c. How many moles of HClO4 are in 1.000 L
Cost benefit analysis : Australian Standard for lighting to firstly ensure compliance with the standard and compatibility with current fixtures (T8 linear fluorescent);
Find the frequency of the wave : The distance between two successive minima of a transverse wave is 2.57 m. Five crests of the wave pass a given point along the direction of travel every 12.4 s. Find the frequency of the wave
How many grams of water are in the same solution : How many grams of perchloric acid, HClO4, are contained in 37.6 g of 70.5 wt% aqueous perchloric acid. How many grams of water are in the same solution.
Determine the governing load combination for both moments : A beam that is part of a rigid frame has end moments and mid-span moments for dead, live, and earthquake loads. Determine the governing load combination for both negative and positive moments at the ends and mid-span of the beam.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Derive an expression for the mole fraction of h3po4

150,000 mol of aqueous phosphoric acid (H3PO4) solution contains 5.00% H3PO4 by moles. The solution is concentrated by adding pure H3PO4 at a rate of 20.0 L/min.

  What will be the decrease in the volume of the block

A rectangular block of aluminum 30 mm × 60 mm × 90 mm is placed in a pressure chamber and subjected to a pressure of 100 MPa. If the modulus of elasticity is 70 GPa and Poisson's ratio is 0.333

  Determine the most economical alternative of return analysis

Using Rate of Return Analysis, determine the most economical alternative below. Assume a minimum attractive rate of return of 6%, and a 5-year life with no salvage value for each. The alternatives are mutually exclusive

  Unit of measurement and unit of payment

Write the unit of measurement and unit of payment of following items. 1) Earthwork in excavation in foundation. 2) Framwork. 3) Steelwork in trusses. 4) Damp proof course D.P.C. 5) Cement.

  Determine how much area will be required for the landfill

If the landfill is to be constructed to a depth 4 cells, how much area will be required for the landfill if it is to serve the solid waste disposal needs for Tippecanoe County for the next 30 years

  Is the work on the ball recoverable

A 1kg ball is dropped from the top of a cliff and falls with a constant acceleration due to gravity. Assume that effects of air resistance can be ignored.

  Pulling automobile by means of two ropes

A disabled automobile is pulled by means of two ropes as shown. The tension in AB is 400 lb and the angle is 20. knowing that the resultant of the resultant of the two forces applied at A is directed along the axis of the automobile, determine by ..

  Determine remaining load carrying capacity of cracked beam

a reinforced concrete beam with a section of 12 inches width and 24 inches depth is reinforced with 3no. 9 bars. fc'=5000psi and fy=60000psi. a 2 inch cover is used and the beam has a simply supported span lenght of 15ft.

  Calculate the concentration of 137 cs in cows milk

After the Chernobyl accident, the concentration of 137Cs in milk was proportional to the concentration of 137Cs in the glass that cow consumed. The concentration in the grass was, in turn, proportional to the concentration in the soil.

  Determine the shear stress in the water at y

The velocity distribution for water (20 C) near a wall is given by u=a(y/b)^1/6 where a=10m/s, b=2mm, and y is the distance from the wall in mm. Determine the shear stress in the water at y=1mm. [viscosity of water at 20 C = 1.81 x 10^-5]

  Define when would wells start interfering with each other

One of the wells pumps at a rate of 1240 m3/ day and the second well pumps at 850 m3/ day. If the aquifer has a transmissivity of 2000 m2/ day and a storage coefficient of 4 x 10^-4, when would the wells start interfering with each other

  What is the total volume of the vocs emitted each day

Assume that there were 1,100,000 vehicles making a 28.5-mi round trip per day, the average vehicle emission rate for VOCs is 1.3 g/VM , and the molecular weight of the VOC emissions from the mobile sources can still be represented by that of metha..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd