Determine frequency of the signal to be sampled

Assignment Help Electrical Engineering
Reference no: EM13228222

antialiasing and anti-imaging active filter

Sampling rectangular pulses (sampling clock) set as the following.

Vp (pulse value) = -5 volts, Period: 0.125 ms, Pulse width 0.02 ms

Sinusoidal voltage source set as the following:

Frequency = 1000 Hz , Vp (amplitude)=1 volts=0.707 rms, DC offset = 1 volt

Answer these questions based on above info:

The cutoff frequency
Frequency of the signal to be sampled
Sampling period
Sampling frequency
Is the sampling theorem satisfied? Justify your answer.
Predict the frequencies and estimated voltage amplitude of each frequency in the range from 0 Hz to 10 kHz of the sampled signals according to the sampling theorem.

Reference no: EM13228222

Questions Cloud

Find what would the sensor output voltage be : A potentiometer with a total range of 350° is supplied with a voltage of 12 Vdc. Find the output voltage for an angle of 135°. An absolute optical rotary encoder has five tracks. How many bits is the output
Define how many grams of sodium azide are needed to react : How many grams of sodium azide, NaN3 are needed to react by the equation below in order to inflate a 50.0: air bag with N2(g) at 298K and 1.20 atm? NaN3(s) -------> Na (s) + N2
Explain what mass of ozone is taken into the lungs : Typically an adult will inhale 2.1 L of air per breath. What mass of ozone is taken into the lungs per breath by an adult breathing air containing 1.57 x 10^-4 micro(ug) grams of ozone per cm^3 of air?
State a chocolate caramel pecan piece of candy contains : A chocolate caramel pecan piece of candy contains 115 food calories (CaI). If the heat energy contained in the piece of candy were transferred to 53.5 kg of water at 25.0 C, what would be the final temperature of the water? [Specific heat of H2O =..
Determine frequency of the signal to be sampled : antialiasing and anti-imaging active filter Sampling rectangular pulses (sampling clock) set as the following. Vp (pulse value) = -5 volts, Period: 0.125 ms, Pulse width 0.02 ms Sinusoidal voltage source set as the following: Frequency = 1000 Hz , Vp..
Explain nitroglycerin c3h5(no3)3 detonates into n2 : nitroglycerin C3H5(NO3)3 detonates into N2, O2, CO2, and H2O. In addition 6.26 kJ of heat is given off per gram of nitroglycerine denotated. what is the specific heat when 4.65 g of N2 is formed
How does apple benefit from such a change : It will need new power chargers, new products by suppliers such as iHome whose products have built in slots for charging etc. How does Apple benefit from such a change? How does it benefit suppliers of accessories?
Design all components down to gate level : The circuit will have as inputs a minimum of two inputs; the binary equivalent of two decimal numbers of not greater than (10,000)10. The circuit will produce a minimum of two outputs, the quotient and the remainder.
Volume of co2 gas is produced by the complete combustion : What volume of CO2 gas is produced by the complete combustion of 2.6L (C3H8) gas? Assume all gas volumes are measured at the same temperature and pressure. C3H8 + 5O2 ---> 3CO2 + 4H2O

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the impulse response fpr the filter

Find the impulse response fpr the filter? How many nonzero terms does the impulse response contain?

  Explain saturated and unsaturated synchronous reactance

Saturated and unsaturated synchronous reactance, The following readings are taken from the results of an open- and a short-circuit test on a 9375-kVA three-phase Y-connected

  Design a circuit that takes an input signal that can swing

For input signal voltages between these limits, the input should pass unaltered to the output. The peak current drawn from the input source may not exceed 1mA. You may use any circuit component we've studied except opamps.

  Determine the maximum and minimum spectral frequencies

Determine the maximum and minimum spectral frequencies received from a stationary GSM transmitter that has a center frequency of exactly 1950.000000 MHzassuming that the receiver is traveling at speeds of.

  What information is provided in each of the three bytes

1. A signal with a range of 0-12 V is sampled with an 8-bit ADC. What is the change in voltage (delta) between digitized levels 2. Using the SPI, we send three bytes to the LTC2600 DAC. What information is provided in each of the three bytes

  Determine the surface charge density on each conductor

Determine the surface charge density on each conductor.

  Express the boolean function in sum of products

1. Express the Boolean function f(X,Y,Z) = XY  + X(Y + Z) in sum of products form showing the sum all nonzero minterms. 2. Express the Boolean function f(A,B,C,D) = A(B + BC) + ACD in sum of products form showing the sum all nonzero minterms.

  Determine the entropy generated for the process

An adiabatic piston cylinder contains 1 kg of R-134a. Initially the conditions inside the piston are 200 kPa and 0 degrees C. An electric heater inside the device runs with constant voltage of 110 V and a constant 0.1A of current for one hour

  Find rates at which heat is absorbed from the hot reservoir

The following heat engines produce power of 95,000 kW. Determine in each case the rates at which heat is absorbed from the hot reservoir and discarded to the cold reservoir. A Carnot engine operates between heat reservoirs at 750 K and 300 K.

  Determine whether the element is active or passive

1) Modern technology has produced a small 1.5-volt alkaline battery with a nominal stored energy of 150 joules. For how many days will it power a calulator that draws a 2-mA current 2)The current entering the positive terminal of an element is

  Find the mass flow rate in sec at inlet and mass flow rate

steam flows through a turbine one inlet and two exits with know condition at the steady state ( hints: h1=3231KJ/kg, h2=2812 KJ/kg , specific volume (v)= 0.0994 m^3/kg , at p= 30 bars,v=0.4045m^3/kg, at p=5 bars, no potential and kinetic energy ch..

  Calculate the total apparent power supplied by the source

A three-phase transmission line having a reactance of 120 ohms per phase is connected to a wye-connected load whose resistance is 160 ohms per phase. If the supply volatge is 70kV line-to-line, calculate a) The line-to-neutral voltage per phase.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd