Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A hoist mechanism is attached to the back of a pickup truck. The crate being moved by the hoist shown below weighs 200 lbs. Note: Point A is directly above point B and the vertical distance between points A and B is 16 inches.
1) Determine the force exerted by the hydraulic cylinder on the boom ACD.
2)Determine the reaction forces acting on the boom at the pin connection, point A.
3)Write the forces found in part 1 and 2 above as Cartesian vectors.
The air transport B is flying with a constant speed of 480 mi/hr in a horizontal arc of 9-mi radius. When B reaches the position, aircraft A, flying south-west at a constant speed of 360 mi/hr
a cantilevered bean has a lenght of L, a cross section area of A, and a flecural rigidity of EI. The free end is free to rotate and displace due to bending. derive the stiffnes of the cantilevered bean. Assume small deformations.
How does aggregate size influence the coefficient of permeability of concrete? List other factors that determine the permeability of concrete in a structure.
A particular unit cell is cubic with ions of type A located at the corners and facecenters of the unit cell and ions of type B located at the midpoint of each edge of the cube and at the body centered position.
5,000 gpd of primary sludge at 5% solids (50,000 mg/l) and 5,000 gpd of biological treatment sludge (10,000 mg/l) are blended, then thickened to 8% solids. What volume of supernatant is returned to the reactor
A beam is 11.5m long. There are two lifting points at 2.2m from each end of the beam. Beam self weight = 4kNm superimposed live load = 12kNm. How to determine what the bending moments are at the lifting points
The ½ inch pipe was found to have an average friction factor of 0.0129 and the ¾ pipe had an average friction factor of 0.0209. The length of the pipes between the two manometer connections are 60 inches each.
The median value of the rupture strength was 300 MPa. The ceramic is to be used for components with dimensions l=50mm, b=d=5mm loaded in simple tension along their length. Calculate the tensile stress that will give a probability of failure of the..
A complete mix activated sludge plant operates at design Q, with the reactor tank volume set by a nominal= 6 hours.. a) It was anticipated that it would operate at 25% RAS for an expected Xr= 2,000 mg/l. What would the actual be
If the max load is applied to the cylinder (6"x12") or (150x300mm) up to P=500 kips, what would be the compressive strength of concrete for (a) cylinder, (b) 150mm cube, and (c) 200mm cube.
The effluent contains 20 mg/L of solids and 20 mg/L of BOD the biological treatment process produced .32 kg of bacterial solids per kg of BOD removed
During a 5 hour storm event, the precipitation over a 230-acre area is 1.5niches. There is constant infiltration at a rate of 0.12 inches/hour and the depession storage is 17 acre-ft. Is there any runoff from the area during the storm
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd