Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Two forces are applied to the vertical post. Determine the force and couple at O equivalent to the two forces.
Determine the location e of the shear center, pt. O, for the thin-walled member having the cross section shown. The member segments have the same thickness t.
A tape is calibrated and found to measure 100.04ft between the 0- and 100-ft marks. What measurements should be laid out to establish a horizontal distance of 682.25ft?
A wet sand sample has a volume of 4.63 * 10^-4 m^3 and weighs 8 N. After oven-drying, the weight reduces to 7.5 N. Calculate the water content, void ration, and degree of saturation.
The road is in good, dry conditions until 160 ft before the stalled car where it is wet and stays wet for the remaining length. What is the minimum distance from the stalled car at which the driver could apply the brakes and still stop before hitt..
An 8.5 m compacted fill is to be placed over the soil profile. Consolidation tests on samples from points A and B produced the following results. a) Calculate the consolidation settlement caused by the weight of this fill.
a) The maximum flow rate that can be achieved without cavitation occurring in the piping system. b) The maximum elevation of the highest point of the piping system to avoid cavitation.
A regular hexagonal pyramid has an upper base edge of 16 ft. and a lower base edge of 28 ft. if the volume of the frustum is 18041 ft^3., find the lateral area of the frustum.
Two control points A "station" (1000E, 1000N) and B "backsight" (594.22E, 877.68N) are available within the area. Indicate the procedure to satisfy the orientation and calculate the required total station reading towards B.
Water, initially dry saturated vapour at 4 bar, lls a closed rigid con- tainer. The water is heated until its temperature is 400C. Determine the work done and the heat transfer.
What are the important findings in Austin Road Co. v. OSHRC and Builders Steel Co. v. Marshall? Your response should be approximately 200 - 300 words and include a reference citation for your response.
To remove a nail, a small block of wood is placed under a crowbar, and a horizontal force P is applied as shown. Knowing that the maximum vertical force needed to extract the nail is 2600 N and that the horizontal force P is not to exceed 290 N, d..
A piston cylinder is initially at a state of 60c, 200kpa. Heat is added to the system from 500c reservoir until the final pressure is 400kpa. the mass of the air is 2kg, the spring constant is 1000kn/m and the cross sectional area of the piston is..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd