Determine for the cycle the mass flow rate of condenser

Assignment Help Mechanical Engineering

Reference no: EM13640509

Water is the working fluid in an ideal rankine cycle. SUPERHEATED VAPOR enters the turbine at 8 MPa, 480 oC. The consenser pressure is 8 kPa. The net power output of the cycle is 100MW. Determine for the cycle:

a) rate of heat transfer to the working flui passing through the steam generator, in kW.

b) the thermal efficiency

c) the mass flow rate of condenser cooling water in kg/h, if the cooling water enters the condenser at 15 oC and exits at 35oC with negligible pressure change.

Reference no: EM13640509

Questions Cloud

Evaluate the power needed to overcome this force use : a jet transport aircraft cruises at 12 km altitude in steady level flight at 820 kmhr. model the aircraft fuselage as a

A plane flies at an airspeed of 255 kmh a wind is blowing : a plane flies at an airspeed of 255 kmh. a wind is blowing at 75 kmh toward the direction 60deg east of north.a in what

Verify this calculation of drag coefficient estimate the : the resistance to motion of a good bicycle on smooth pavement is nearly all due to aerodynamic drag. assume that the

Two students a and b are both registered for a probability : two students a and b are both registered for a probability class. neither student has a sterling attendance pattern.

Determine for the cycle the mass flow rate of condenser : water is the working fluid in an ideal rankine cycle. superheated vapor enters the turbine at 8 mpa 480 oc. the

Water drips from the nozzle of a shower onto the floor 203 : water drips from the nozzle of a shower onto the floor 203 cm below. the drops fall at regular equal intervals of time

A bullet is fired through a board 140 cm thick with its : a bullet is fired through a board 14.0 cm thick with its line of motion perpendicular to the face of the board. if it

For the purpose of redesigning their manufacturing process : a 23nbspfactorial is used by an a process engineer to study the effects of cutting speed a tool geometry b and cutting

In order to pass the full pump flow through the valve at : a pressure relief valve contains a poppet with a 4.20 cm2 area on which system pressure acts. during assembly a spring

User Account

All Pages