Determine flow depth-velocity and froude number after jump

Assignment Help Civil Engineering
Reference no: EM13318219

Water is being transported in a wide channel at a depth of 0.6 m and a velocity of 10 m/s undergoes a hydraulic jump. Determine the flow depth, velocity and Froude number after the jump, the head loss associated with jump, the energy dissipation ratio, and the wasted power production potential due to the hydraulic jump.

Reference no: EM13318219

Questions Cloud

Negate the nebular hypothesis : Why don't the following negate the nebular hypothesis: Venus rotates slowly in the opposite direction to the other planets, Earth's axis is tilted to the plane of its orbit, and Uranus's axis is near the plane of its orbit?
What magnetic force does each segment exert on the other : Two high-current transmission lines carry currents of 27.0 A and 80.0 A in the same direction and are suspended parallel to each other 35.0 cm apart. what magnetic force does each segment exert on the other
Explain what is the average atomic mass of silicon : The element silicon has 3 isotopes with the masses and natural abundances shown in the table. Mass of Isotope Natural abundance 27.97693 92.23 28.97649 4.67 29.97376 3.10 What is the average atomic mass of silicon
Determine the deceleration of a if smooth golf ball : The golf ball has a diameter of 1.70 in and weighs 0.099 lb. Assuming standard atmospheric conditions (mu, u air = 3.74 * 10^-7 lb-s/ft2 and rho = 0.00238 slug/ft3)
Determine flow depth-velocity and froude number after jump : Determine the flow depth, velocity and Froude number after the jump, the head loss associated with jump, the energy dissipation ratio, and the wasted power production potential due to the hydraulic jump.
Compute the heat that would be generated for a reaction : Assume the value of Delta H for this reaction is -3.8*10^2 kJ/mol The formula is 4. 2HCl (l) + Mg (s) ??? MgCl? (s) + H? (g) Assume magnesium reacts with excess HCL. Calculate the heat that would be generated for a reaction of .20 g of magnesium m..
Find the rms values of the electric and magnetic fields : A laser pulse has an energy of 24 J and a beam radius of 2 mm. Find the rms values of the electric and magnetic fields in the pulse
Determine relationship between discharge and parameters : The flow is fully developed and laminar. Make use of the Navier Stokes equation to determine the relationship between the discharge and the other parameters involved, for the case in which the change in pressure along the channel is zero.
Explain what is the minimum error in the momentum (mv) : A particular X-ray microscope can measure the position of a particle to with 1.0X10^-10 m. What is the minimum error in the momentum (mv)

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what minimum value of coefficient of traction

A wheel tractor-scraper is operating on a level grade, assuming no power derating is required for equipment conditions, altitude, and temperature.

  How high can students climb just before the pole buckles

Assuming the center of gravity of the student aligns with the axis of the pole and the pole has an elastic behabior, how high can they climb (in meters, m) just before the pole buckles

  Describe which one will be harder to remediate and why

if a source of groundwater gets contaminated with a DNAPL and another one gets contaminated with a LNAPL, which one will be harder to remediate and why

  Calculate total co2 emissions from two polices from 2011

A more conservative increase from 27.5 mpg in 2011 to 35 mpg by 2020 is supported widely in Washington. California and 13 other states + the District of Columbia hope to increase that stander to 35 mpg by 2017 and 40 mpg by 2020.

  Determine what is the actual entropy at the turbine exit

The steam flow rate entering the pipe is 2500kg/hr. Due to heat loss from the pipe to the surrounding air (at 25 C) 20 kg/hr of condensate is formed in the pipe and removed at the end of the pipe.

  Explain is the flow field compressible or incompressible

Consider the flow field where angular velocity w is equal to 2pi rad/s ( a physical frequency of 1 Hz). Is this flow field compressible or incompressible

  Determine the magnitude of force p to produce

A thin-walled cylindrical tank of radius r is subjected simultaneously to internal pressure p and a compressive force P through rigid end plates. Determine the magnitude of force P to produce pure shear in the cylindrical wall.

  Determine angular velocity of sprinkler about the bearing

Water enters a two-armed lawn sprinkler along the vertical axis (normal to the page) at a rate of 80 L/s and leaves the sprinkler nozzles as 1.5-cm diameter jets at an angle of from the tangential direction.

  How many laterals would be required in the leaching field

A time interval of 1.5 hours is recorded for a 6 inch drop of water level in a percolation (perc) test hole. What is the perc rate. How many laterals would be required in the leaching field to serve a 5 bedroom house,

  What is the mass of the fish

A fish hanging from the bottom of the spring oscillates vertically at a frequency of 2.00 Hz. Ignoring the mass of the spring, what is the mass of the fish?

  Determine what is the damping coefficient b to a spring

A 5.0-kg block is attached to a spring whose force constant is 125 N/m. The block is pulled from its equilibrium position at x = 0 m to a position at x = + 0.687 m and is released from rest.

  Determine time required for the bed to complete a full cycle

The velocity of the bed is limited to a maximum value of 150mm/s to the right and 300mm/s to the left; the acceleration is successively equal to 150mm/s^2 to the right, zero 150 mm/s^2 to the left, zero, etc.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd