Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The natural ground water table at a site is located at a depth of 2m below the ground water. Laboratory tests reveal that the voidratio of the soil is 0.85 while the grain size corresponding to 10%finer is 0.05 mm. Determine the depth of the zone of saturationbelow the ground level. Assume C=0.3x10-4 m2
A water jet of diameter 2 inches and speed of v=60 ft/s is filling a tank at a 70 degree angle. The tank has a mass of 25 lbm and contains 6 gallons of water. The water temperature is 70 degrees F.
a stream f gas flowing at 3000 cfm has a particulate loading of 50gr/ft what is the allowable exit loading if 95 % collection efficiency is required. what is the mass of the particles collected
A fluid film 0.1 mm thick separates solid and surface. The fluid viscosity is 0.04 N*sec/m^2. Assuming the velocity distribution in the film is linear, find the terminal velocity of the block. The area of the cube in contact with the film is 0.25 ..
The 30-Mg freight car A and 20-Mg freight car are moving towards each other with the velocities of VA= 20km/h and VB=10 km/h. A spring mounted on A has k=3 MN/m Determine the maximum compression of the spring mounted on car A.
A dam spillway is to be tested using kinematic similitude (Froude scaling) with a 1:20-scale model. The model flow has an average velocity of 0.7 m/s and a flow rate of 0.06 m3/s.
A steel bar is attached to a wood support beam with four 20 mm diameter lag screws. The steel bar is 75-mm-wide by 6-mm-thick. For the steel bar, the yield strength is 260 MPa and the ultimate bearing strength is 350 MPa.
A maximum flow rate of 6 CFS is available for a river model. This corresponds to 30,000 CFS for the prototype. What is the scale of the model in terms of the prototype size
A hydraulic transition 100 ft long is used to connect two rectangular channels, 12ft and 6ft wide. The design discharge is 500 cfs, mannining coefficient=.013 and the slopes of the channels are both .0009.
A 10-mm diameter bar of 1040 carbon steel is subjected to a tensile load of 50,000 N, taking it beyond its yield point. Calculate the elastic recovery (or strain) that would occur upon removal of the tensile load.
A stainless steel pipe (k= 17 W/m?C) is being used to convey heated oil. The inside surface temperature is 130?C. The pipe is 2 cm thick with an inside diameter of 8 cm. The pipe is insulated with 0.04 m thick insulation
a concrete test cylinder is loaded with p= 100k (445 kn) and resulting shortening of 0.036" (0.0914 mm). determine the unit strain developed in the concrete.
The concentration of trichloroethelyne (TCE) in an air sample near a hazardous waste landfill is 34 ppm, the ambient air temperature is 31 degrees C, and the atmospheric pressure is 0.94 atm. What is the TCE concentration in mg/m^3
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd