Determine current per array system and gradient angle

Assignment Help Electrical Engineering
Reference no: EM13226817

Photovoltaic System

•Expected capacity of 50 kW.

•Select and specify panels (use the Internet for manufacturers) and make a table for the panel specifications including:
-Maximum output power, voltage, and current per module; short circuit current; dimension; weight; maximum output power, voltage, and current per array system; gradient angle; frequency; and grid voltage.

•Draw a complete circuit diagram for the entire array of the photovoltaic system that supplies 50 kW.

Hard to find all the information, Just want to ask for people who can give some good webside which can provide all the informationat at lease price,maximum output power, voltage, and current per module; short circuit current; dimension; weight; maximum output power, voltage, and current per array system; gradient angle; frequency; and grid voltage.

Reference no: EM13226817

Questions Cloud

Explain liquid compound combusting in o2 : Write a balanced equation showing one mole of this liquid compound combusting inO2 (gas) to produce CO2 (gas) and H2O (liq).
Ethical perspectives - kants categorical imperative : Should government regulate executive compensation or not? Discuss your response using one ethical perspective.
What is the power supplied by the current source : e) What is the value of C such that the energy stored in the capacitor equals the energy stored in the inductor f) How much energy is stored in the 3.9?F capacitor Use the formula for the energy. g) What is the power dissipated in the resistors
Find the attenuation rate after a wave propagates on line : A transmission line is specified by the following, while operated at omega w=6*10^8 rad/s, L'= 0.4*10^-6 H/m, C'=40*10^-12 F/m, G'=80*10^-6 S/m, and R'=20 ohms/m. Find the attenuation rate after a wave propagates 10 meters on this line.
Determine current per array system and gradient angle : Hard to find all the information, Just want to ask for people who can give some good webside which can provide all the informationat at lease price,maximum output power, voltage, and current per module; short circuit current; dimension; weight; ma..
Implement and require extensive organizational change : They cannot provide value if they are implemented atop flawed processes or if firms do not know how to use these systems to measure performance improvements. Employees require training to prepare for new procedures and roles.
Calculate the signal to noise ratio given rms noise voltage : 1. Given R = 50Kohm and C = 100nF what is the frequency of oscillation 2. Given a required frequency of oscillation of f = 10kHz and R = 8kohm, what should the value of C be Calculate the signal to noise ratio given RMS Noise Voltage = 20mV and RMS S..
Pursuit of operational excellence : ES' attempt to create a level of ‘intimacy' between the company and its main suppliers and customers. Explain what we mean when we use the term ‘intimacy' in sense. How does this intimacy contribute to the pursuit of operational excellence?
Describe the ionic compound ax is likely to form : Predict whether or not the ionic compound AX is likely to form. In this compound, A forms the A+ cation, and X forms the X?anion.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Write a matlab program to compute the capacity

Write a MATLAB program to compute the capacity of an AWGNC with a given bandwidth and for equally spaced values of between and including and (in dB).

  How many atoms are there in the unit cell

(a) How many atoms are there in the unit cell characterizing the Si lattice (b) Verify that there are 4.994 X 1022 atoms/cm' in the Si lattice at room temperature. (c) Determine the eenter-to-center distance between nearest neighbors in the Si lattic..

  When the radiator area a is a minimum for temperature ratio

A heat engine operating in outer space may be assumed equivalent to a Carnot engine operating between reservoirs at temperatures TH and Tc The only way heat can be discarded from the engine is by radiation

  Sketch the system block diagram

Select an appropriate QAM signal constellation, carrier frequency, and the roll-off factor of a pulse with a raised cosine spectrum that utilizes the entire frequency band. Sketch the system block diagram and the spectrum of the transmitted signal..

  Calculate the mass of the cooling water in a minute

an electrical transformer dissipates heat equivalent of 3000 kW/h. the inlet and outlet temperatures of the cooling water are 55C and 15C respectively. calculate the mass of the cooling water in a minute.

  What is the mean number of transmissions required

If a frame is damaged then in this network the receiver sends back a request for retransmission. (For simplicity, assume all these requests arrive back perfectly at the sender). What is the mean number of transmissions required to successfully tra..

  Digitizing an audio signal and pam and adc

Digitizing an Audio Signal, PAM, ADC, An audio signal has a bandwidth that extends from 100 Hz to 10 kHz. The signal is sampled to create a PAM signal and then digitized by an analog to digital converter (ADC) that has 8 bits.

  Determine the voltage regulation at rated load

A 75-kVA, 230-V/115-V, 60-Hz was tested with these results: Open-circuit test: 115 V, 16.3 A, 750 W; Short-circuit test: 9.5 V, 326 A, 1200 W a) Determine the voltage regulation at rated load, 0.8 power factor lagging.

  Find the electric field intensity produced by charges

Find the electric field intensity at (0,0,75000) produced by 50,000 0.1 C charges along the x-axis spaced at 1 meter apart starting at (1,0,0) and 50,000 0.2 C chargers along the y-axis spaced at 1 meter apart starting at (0,1,0).

  What memory modules are needed

What memory modules are needed if the customer wants 1.25GB of RAM?(What capacities and how many of each capacity?)

  Design a phase shift circuit at a frquency

1- Draw a circuit whose output goes to + V sat . When the input signal is below -4V. the output should be -V sat, when the input is above - 4V  2- Design a - 90 phase shift circuit at 1590 Hz , Then for your design calculate 0 at 15 Hz, & 15 KHz

  Design a circuit that provides an output voltage

(a) Design a circuit that provides an output voltage which indicates the amount of fuel remaining, so that 1 V=empty and 5 V=full. (b) Design a circuit to indicate the rate of fuel consumption by providing a voltage output calibrated to yeild 1V = 1..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd