User Account

All Pages

Determine change in resistance when the temperature rises

Assignment Help Electrical Engineering
Reference no: EM13229569

A platinum resistance coil has a resistance at O0 C of 100 . Determine the change in resistance that will occur when the temperature rises to 30°C if the temperature coefficient of resistance is 0.0039 K-1.

Reference no: EM13229569

Questions Cloud

What value of resistors are required for the voltage divider : A HCS12 ATD is set to 8-bit unsigned mode. A temperature sensor measuring 0 to 100 degrees with an output of 25 mV/degree is attached to the input. The ATD low voltage reference is attached to ground and the high voltage reference
Describe target markets of each branded supermarket : Draw the layout of each store and if possible include photographs-make sure you indicate the brand on the diagram
Find a minimum two level circuit using and gate : Find a minimum two level circuit (corresponding to the sum of products expressions) using AND and one OR gate per function for each of the following sets of functions: f(a,b,c,d) =fm(1,3,5,8,9,10,13,14) g(a,b,c,d) =fm(4,5,6,7,10,13,14)
Explain the ratio of the number of atoms of the isotopes : The ratio of the number of atoms of the isotopes 69Ga and 71Ga in eight samples from different sources was measured in an effort to understand differences in reported values of the atomic mass of gallium
Determine change in resistance when the temperature rises : A platinum resistance coil has a resistance at O0 C of 100 . Determine the change in resistance that will occur when the temperature rises to 30°C if the temperature coefficient of resistance is 0.0039 K-1.
Explain what would be the concentration of each of the ions : NaCl is added to 33.4ml of 0,327M AgNO3(silver nitrate). What would be the concentration of each of the ions(ie Ag+, NO3- Na+ and Cl-) in the reaction mixture after the reaction.
Demonstrate positive leadership skills : Identify and apply appropriate theory and models of leadership and have developed self-awareness of their own personal attributes relevant to leadership.
What will be the output voltage from the bridge for a change : What will be the output voltage from the bridge for a change in temperature of 20o C The supply voltage to the bridge is 6.0 V and the temperature coefficient of resistance of the platinum is 0.0039 K-1.
Complete and balance the equations and the oxidizing agents : Complete and balance the following equations, and identify the oxidizing and reducing agents. (Recall that O atoms in hydrogen peroxide, H2O2, have an atypical oxidation state.)

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate the electric current moving through

A glass tube with a cross-sectional area of 9^-2 m^2 contains an ionizd gas. The densities are 10^15 positive ions/m^ and 10^11 free electrons/m^3. Under the influence of an applied voltage, the postive ions are moving.

  Which design would choose using maximax rule

Consider the following matrix of expected profits (in units of $1K) versus potential future material price scenarios (P1 - P5), for five different designs (D1 - D5): P1 P2 P3 P4 P5 D1 10 20 30 40 50 D2 20 25 25 30 35

  What is the sinusoidal expression for the current

The voltage across a 0.2 H coil is given. What is the sinusoidal expression for the current?

  Design a three mode pid controller

A liquid level system converts a 4-10 m level into a 4-20mA current. Design a three mode controller (PID im assuming) that outputs 0-5 volts with 50% PB, 0.03 min integration time, and 0.05 min derivative time. Fastest expected change time is 0.8 ..

  How a transformer works

How a transformer works and apply those rules to a transformer where the primary core cross-sectional area is twice.

  What is the maximum number of consecutive bits

What is the maximum number of consecutive bits that are in error for a transmission through this channel if the data rate is 10Kbps? If the data rate is 11 Mbps?

  Find the efficiency as an autotransformer delivering rated

A 5 KVA 480/120 V single phase transformer is to be used as an autotransformer to transform a 600 V source to a 480 V supply. As a single phase transformer delivering rated load at 0.8 PF Lag its efficiency.

  What is the complex admittance in siemens

An input signal of 10V at 0o is applied to a parallel RLC circuit with resistor R = 10 , inductive reactance XL = 20 , and a capacitive reactance XC = 10 . All three components are connected in parallel to the source.

  Define differences in the theoretical and measured values

Include worked solution, a discussion of any differences in the theoretical and measured values and screenshots that show your measurements and paste them into a document

  Find the probability of error in digital communication

A digital communication system transmits one of the three values -1,0,1. A channel adds noise to cause the decoder to sometimes make an error. The error rates are 12.5% if a -1 is transmitted, 75% if a 0 is transmitted, and 12.5% if a 1 is transmi..

  Design an integral controller

Improve the controller designed in part by introducing a mechanism for the disturbance compensation at the plant input. Illustrate advantage of the improved controller by applying the fast varying piecewise constant reference input vector and sinu..

  What is the range of doping and pick a doping concentration

Restricting yourself to nondegenerate dopings and also requiring the resistance to be readily measured with a hand-held multimeter (say 1  R 1000), what is the range of doping Pick a doping concentration in the mid range.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd