Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
two forces applied as shown to a hook support. knowing that the magnitude of P is 35 N, determine by trigonometry the required angle if the resultant R of the two forces applied to the support is to be horizontal and the corresponding magnitude of R
A lagoon with a volume of 1200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100m^3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10mg/L.
Find the total mass, quality of steam, specific volume, specific enthalpy, and specific internal energy.
A 75g , 30cm--long rod hangs vertically on a frictionless, horizontal axle passing through its center. A 12g ball of clay traveling horizontally at 2.5m/s hits and sticks to the very bottom tip of the rod.
A concrete building has floor area 10 m by 20 m and is 4 m high. THe building has four windows with a height 1.6 m and a width 2 m. After 10 minutes gases in the room have an average temperature of 700 degree Celcius.
Using 1630.56 kN as the ultimate capacity determine the diameter of a drilled shaft pile that would have the same ultimate capacity and depth embedment (11.5 m) using the FHWA method. Neglect shaft resistance. Use a F.S. of 2
Also calculate the deflection of the beam to check that it complies with the design limit of L/200. Only variable actions are required for deflection check.
Knowing that at t= 3s slider block C has moved 57 mm to the right, Determine the velocity of slider block C at t=0, (b) the acceleration of A and C, (c) the change in position of block A after 5s.
Assuming unit surface area, find the conductive heat loss through the furnace wall and the temperature at the interface of the fire clay and red brick.
Which software do we use to calculate force and moment, and draw shear and moment diagram? I really need this software to design my structural project. Please helps me... thank you so much.
The volume of fill required is 2500 cubic meters. Find the volume of soil that must be excavated from the borrow pit to furnish the required volume of fill. (in cubic meters).
Two transmission belts pass over sheaves welded to an axle supported by a thrust bearing at B and a journal bearing at D. The sheaves A has a radius of 50mm, and the sheave at C has a radius of 40mm.
A rear-wheel-drive 3000lb drag race car has a 200-inch wheel base and a center of gravity 20 inches above the pavement and 140 inches behind the front axle. The owners wish to achieve an initial acceleration from rest of 15 ft/s on a level paved s..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd