Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.Compute the amount of chlorine required for disinfection in pounds per day(lb/d). Estimate the annual cost for disinfection using chlorine.
Flow Rate= 30 milloin gallons per day.
2.Determine appropriate dimensions of the finished water clearwells to achieve adequate disinfection using chlorine. Flow Rate Q = 30 million gallons paer day.
3.Cylinders C and D are attached to the end of the cable. if D has a mass of 600 kg, determine the required mass of C, the maximum sag h of the cable, and the length of the cable between the pulleys A and B. The Beam has a mass per unit length of 50 kg/m.
Compute the maximum service (unfactored) concentrated live load that can be applied at 1ft from the free end of the cantilever. Use load and strength -reduction factors from ACI Code Sections 9.2 and 9.3. Also check As,min.
The subsoil at the site is a thick layer of soft alluvial river silts and sands, the bearing capacity of the silt has been found to be in the region of 80 kN/m2. There is a high ground water table present.
the two particles A and B start at the origin O and trevel in opposite directions along the circular path at constant speeds va =.7 m/s and vb =1.5 m/s . Determine the time when they collide and the magnitude
The selection of the runway for a given day is based on wind at the beginning of the day, and once selected will not be changed for the entire day. The airport has a single peak period each day; this is the hour between 4:00 and 5:00pm.
Wastewater enters and anerobic pond at a BOD of 246 mg/L and a flowrate of 0.1 m^3/s. The waste degrades at a rate of 0.40d. Effluent from the lagoon must have a BOD of 23.9mg/L.
calculate the alkalinity as CaC03 of water that contains 85mg/l of HCO3, 120 mg/l of CO3 and 2 m/l of OH.
how do i solve this problem a 14 in diameter rod must be machined on a lathe to a smaller diameter for use as a
A 9,000-lb single wheel load is placed on a PCC slab that is 9.5 in. thick. The concrete has a modulus of elasticity of 5 million psi with a Poisson's ratio of 0.15. The modulus of subgrade reaction is 225 pci.
A roadway is to be designed on a level terrain. The roadway is 500 ft. Six Cross Sections have been selected at 0 ft, 100 ft, 200 ft, 300 ft, 400 ft, and 500 ft. . The cross sections have areas of 130 ft2, 140 ft2, 70 ft2, 110 ft2, 80 ft2, and 25 ..
The natural ground water table at a site is located at a depth of 2m below the ground water. Laboratory tests reveal that the voidratio of the soil is 0.85 while the grain size corresponding to 10%finer is 0.05 mm.
The brass tube AB (E=105 GPa) has a cross-sectional area of 140 mm^2 and is fitted with a plug at A. The tube is attached at B to a rigid plate that is itself attached at C to the bottom of an aluminum cylinder
A cylinder of rock with a Poisson's ratio of 0.422 has ano-load length equal to 17.6 cm and a no-load diameter of 6.20cm. Under an axial compressive load the axial strain is foundto be -3.44 mm/m.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd