Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
In a 2-pole, three-phase PMAC drive, the torque constant and the voltage constant are 0.5 in MKS units. A constant torque of 5 Nm is developed to bring the system from rest to 5000 rpm in 5 seconds. Determine and plot the three-phase current commands. Assume the rotor is initially at angle zero.
he sensor to be used has a transfer function of ? Q volts, where Q is in gal/min, and an output impedance of 2.0 k?. Tests show that the output of the sensor has 60 Hz noise of 0.8 V rms. Design a signal-conditioning system, including noise filter..
Design a circuit that will add either 1 or 2 to a 4-bit binary number N. Let the inputs N3, N2, N1, N0 represent N. The input K is a control signal. The circuit should have outputs M3, M2, M1, M0, which represent the 4-bit binary number M.
why does the instruction set include an INC (DEC) instruction to increment (decrement) a memory byte when the same function could be accomplishe using an ADD (SUB) instruction
Design a combinational logic circuit that compare two 2- bit number. The circuit must have three outputs indicationg if the two numbers are equal, first larger than the second, or the second is larger than the first.
What is the bandwidth occupied by this signal, and the noise bandwidth of the receiver for this signal? Find the BER at the receiver output and the average time between errors.
Write the verilog code for a circuit that counts the number of 1s in a byte. Write the verilog code using a structural approach based on four Half-Adders, two 2-bit adders and one 3-bit adder. Write the test bench code to test the design.
1) For a forwarard converter, derive the minimum value of Vr - as a function of the input voltage Vg, the duty cycle D, and the turns ratio N1/N2 - that will cause the transformer magnetizing current to be reset to zero by the end of the switching..
The circuit will have as inputs a minimum of two inputs; the binary equivalent of two decimal numbers of not greater than (10,000)10. The circuit will also produce a minimum of two outputs, the quotient and the remainder.
a solid cylindrical conductor of raduis a and charge Q is coaxial with a cylindrical shell of negligible thickness,radius b,and charge -Q. FIND THE CAPACITANCE OF THIS CYLINDRICAL capacitor if its length is l.
(a) If a motor at the end of a transmission line has a reactance of 8 ohms per phase, what is the maximum power which the machine can develop, given that the sender voltage is 4kV and the induced voltage Eo is also 4kV.
A serial transmission is set up for 8 bits with odd parity. The first two bytes of data are 01110111 with parity bit 1 and 01101010 with parity bit 0. From this we know that there are no errors in transmission.
A small gasoline engine can put out 24,000 N-m/min of mechanical power. The engine is used to drive an electrical generator that is 70 percent efficient. 1 N-m = 2.78 X 10-4W-h. Find the output of the generator in Watts.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd