Determine ability of pigment to absorb different wavelengths

Assignment Help Chemistry
Reference no: EM131400875

Write one page organic chemistry report.

Follow the instractions on the attachmen.

The experiment consisted of using a spectrophotometer to determine the ability of a pigment to absorb different wavelengths of light in chlorophyll extract. An absorbance graph was to be made and the hypothesis was that the spectrum graph of chlorophyll would have a dip in the green area since the green pigment will be reflected. Using alcohol as the control and chlorophyll extract as the test subject, both materials were placed into a spectrophotometer and wavelength pigments were determined between 400 and 700. Results obtained were lower numbers in the green region and had higher numbers in the blue and red region. Therefore, that is proof that chlorophyll reflects the green wave lengths between 490 and 590. Also, the best absorption of light by chlorophyll is in the red, blue and violet waves.

Introduction

Photosynthesis is the way plants produce food. There are two stages of photosynthesis. First, the light cycle converts light energy to chemical energy. Secondly, the Calvin cycle uses the chemical energy from the light reactions to make sugar. Light travels in wavelengths that range from 380 nm to 760 nm. Pigments are substances that absorb visible light. Different pigments absorb different wavelengths of the light (See Table 1). Wavelengths that are absorbed disappear and wavelengths that are reflected are seen. Plants with chlorophyll appear green since the green wavelengths are reflected and not absorbed. Therefore, the greatest absorption should be in the red, blue, and violet wavelengths. Chlorophylls a and b can absorb a maximum of 600-675 and 400-475 nm ranges and will absorb light in two regions of the spectrum. To test the absorption of pigments a spectrophotometer is used. A graph called an absorption spectrum plots the pigment's light absorption versus the wavelength.

Laboratory Reports

Laboratory reports are an overview of the experiment written in a paragraph. They are similar in form to an abstract. The report should provide a brief introduction that includes the purpose of the experiment. The methods used in the experiment should include enough detail to understand what was done, but not as much detail as a methods section of a research paper. The results of the experiment should include the general outcome and include any error calculations. The discussion should give a brief summary of the experiment and include a brief discussion of the sources of error.

The report should be no longer than 1 page, single spaced, 12 point font (similar to an abstract).

Reports are due on the day of the next lab unless otherwise stated.

Attachment:- Chlorophyll_Rlja.xlsx

Reference no: EM131400875

Questions Cloud

Prepare detail drawings of the bearing housing, belt pulley : Sizes shown on the drawing are nominal. Select proper fit (shaft bases system) sizes using the tables in the Appendix.
Conditions of constrained optimization setting : Give the three first order conditions of constrained optimization setting each equal to zero.
What does the law of one price imply will happen : Suppose that a U.S. dollar buys more gold in Mexico than it buys in Japan. What does the law of one price imply will happen?
Impact of higher prices of imported oil : a) You are interested in looking at the impact of higher prices of imported oil in the overall cost of living. b) The government is interested in whether increases in defense spending are affecting the price level.
Determine ability of pigment to absorb different wavelengths : The experiment consisted of using a spectrophotometer to determine the ability of a pigment to absorb different wavelengths of light in chlorophyll extract.
Draw the gear and one shaft support in full section : A partial top view is required to show the location of the mounting holes. Standard parts are to be used wherever possible, and an item list is to be included on the drawing. Scale 1:1.
Discuss the effects of consumer demand on medical care : Discuss the effects of consumer demand on medical care services or products versus the economic variables of cost, access, and supply.
Interest rate would have on the exchange rate : Explain what effect a reduction in the U.S. interest rate would have on the exchange rate?
Extensions of long-term unemployment benefits : During the Great Recession, as in previous extended recessions, the U.S. Administration stressed job training programs and enacted repeated extensions of long-term unemployment benefits in response to persistently high levels of unemployment .

Reviews

Write a Review

Chemistry Questions & Answers

  Rrange the subsequent substances according to lattice

Utilizing a periodic table, arrange the subsequent substances according to their expected lattice energies, listing them from lowest lattice energy to the highest: LiCl, KCl, KBr, CaO. Use the appropriate symbol to separate substances in the list..

  Molarity of the sulfurous acid

If it takes 46.5 mL of .185M potassium hydroxide solution to neutralize 39.3 mL of sulfurous acid, what is the molarity of the sulfurous acid?

  Explain benzyltriphenylphosphonium chloride

Assume a 95% yield for the formation of the phosphonium ion, how many milligrams of benzyl chloride and triphenyl phosphine would you need to prepare 220 mg of benzyltriphenylphosphonium chloride?

  An unknown salt is either naf nacl or naocl when 0050 mol

an unknown salt is either naf nacl or naocl. when 0.050 mol of the salt is dissolved in water for form 0.500 l of

  Explain diagram for a trigonal bipyramidal crystal field

How would I do that? I have a diagram for a trigonal bipyramidal crystal field and two values are on the diagram. There's a delta 0.19 and a delta 0.79.

  State cyanic acid and isocyanic acid

Cyanic acid (HOCN) and isocyanic acid (HNCO) differ in the position of their electrons, but they are not resonance structures. Explain.

  Explain which salt would precipitate first pbi2 or pbco3

A solution contains 0.10 M of iodide ion I-, and 0.10 M Carbonate ion CO3 2-. If solid Pb(NO3)2 is slowly added to the solution, which salt would precipitate first, PbI2 or PbCO3

  State what is being oxidized and what is being reduced

Write two balanced half reactions for the titration of iodine with sodium thiosulfate. Indicate what is being oxidized and what is being reduced.

  The density of liquid water at 0 degrees celsius is 09987

the density of liquid water at 0 degrees celsius is 0.9987 gcm3 the density of ice at this same temperature is 0.917

  Explain what will the pressure be if the temperature

An ideal gas exerts 114.7 psia in a cylinder at 560 Rankine. What will the pressure be if the temperature is reduced to 492 rankine

  A specific brand gourmet chocolate candy contains 700g of

a specific brand gourmet chocolate candy contains 7.00g of dietary fat in each 22.7 piece. how many kilograms of

  Define saturated calomel electrodes to find the endpoint

Consider the titration of 25.0 mL or 0.010 M Sn^2+ by 0.050 M TI^3+ in 1 M HCL, using pt and saturated calomel electrodes to find the endpoint.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd