User Account

All Pages

Determine a suitable diameter and length of the rod

Assignment Help Electrical Engineering
Reference no: EM13288826

An LVDT Is used to measure the axial deformation a simple bar.The uncertainty in this measurement is ± 0.025mm. A steelbar is to be used to measure a force of 1100N with an uncertaintyof 1 percent. Determine a suitable diameter and length of the rodfor this measurement, assuming the rod dimensions will be known exactly.

Reference no: EM13288826

Questions Cloud

Calculate the current sensitivity of decive if gage factor : A strain gage has a nominal resistance of 120Ω. the gage is installed in a bridge circiut having equal arm resistance of 120Ω qne iw operated as a current-sensitive device with a detector resistance of 350Ω. the voltage source is 4.5 V.
Define what is the partial pressure of each gas : what is the partial pressure of each gas if the total pressure of each gas if the total pressure is 735 mm Hg
Explain what is the pkb for the hypohalite anion : Hypohalic acid, HOX, is a weak acid with a Ka of 3.341x10-8. What is the pKb for the hypohalite anion, OX-, in a 0.8865 M solution of KOX
State nitrogen containing fertilizers is that b/w nh3 and o2 : An intermediate reaction used in the production of nitrogen containing fertilizers is that b/w NH3 and O24NH3(g) + 5O2(g)--> 4NO(g) + 6H2O(g)
Determine a suitable diameter and length of the rod : An LVDT Is used to measure the axial deformation a simple bar.The uncertainty in this measurement is ± 0.025mm. A steelbar is to be used to measure a force of 1100N with an uncertaintyof 1 percent.
What was the initial frequency of the piano wire : a piano note is compared to a tuning fork vibrating at 440 Hz. Four beats per second are discerned by the piano tuner. What was the initial frequency of the piano wire
Explain what is the ph of a 0.5901 m solution of naa : What is the pH of a 0.5901 M solution of NaA. Note: HA is a weak acid with Ka = 6.144x10-8.
Determine the cars position relative to the base of cliff : Your friend's car is parked on a cliff overlooking the ocean on an incline that makes an angle of 24.7° below the horizontal. determine the car's position relative to the base of the cliff
What is the largest value of the closed-loop gain : An noninverting amplifier op amp circuit is operated with V_DD=5Vand V_SS=0V, and the input signal ranges from 0.3V to 0.6V. What is the largest value of the closed-loop gain for which the circuit will perform as a linear amplifier

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Use the method of recursion to solve the equations

use the method of recursion to solve the following problems: compute y[n] for n = 0,1.2, when x[n] = 0 for all n andy[-l] = 2. Compute y[n] for n = 0,1.2, when x[n] = u[n]and y[-l] = 0. Compute y[n] for n = 0,1.2, when x[n] = u[n]and y[-l] = 2.

  Find what is the field intensity at the m2 north pole

Two bar magnets are placed in a straight line with their morth poles 5 cm apart. (a) what is the force of repulsion if M1=25.1*10^-5 Wb and M2=6.28*10^-5 Wb. (b) what is the field intensity at the M2 north pole as a result of the M1 north pole.

  Determine l-c-q and the two cut off frequencies

a series RLC bandpass circuit with R= 30 ohms is designed to have a bandwidth of 5 Mrad/s and a center frequency of 50 Mrad/s. Find L, C,Q and the two cut off frequencies.

  What must be the distance be between filaments 2 and 3

Filament 1 is on the left, filament 2 is in the middle, and filament 3 is on the right. Filaments 1 and 2 have currents of 1 A in the ba z direction, and filament 3 has a current of 2 A in the ba z direction

  Calculate the per-phase induced voltage and input current

A synchronous motor has a per-phase voltage of 220V and a synchronous reactance of 10. (a) If it draws a total input power of 7.5kW at a torque angle of 30 deg, calculate the per-phase induced voltage, input current and power factor.

  Determine the relative permittivity of the dielectric

Determine the relative permittivity of the dielectric, the maximum and minimum electric field intensities in medium 1 and the electric field intensity in medium 2.

  Find the solution to the differential equation in part a

(a) Write down a differential equation modeling the current I(t) (b) Assume that V=0 and I(0)=Io. Find the solution to the differential equation in part a. (c) Assume that V>0 is a constant and I(0)=0. This corresponds to adding a switch to the circu..

  Find what is the maximum power dissipated in the load

What is the maximum power dissipated in the load when the Thévenin voltage is 21 V cos(52 rad/s t + 82°), the Thévenin impedance is 102 -j 184 ohm and the load impedance is 102 + j 184 ohm

  Determine what is the transmission angle

A 5 GHz parallel polarized wave with amplitude 5 V/m is oblique incident from an air of (z 0. The angle of incidence is 53.13 deg. What is the transmission angle

  Give circuit analysis to quantitatively provide expression

Suppose you want to use external components to configure a comparator in order to provide hysteresis for the input. Show how you would configure such a comparator with hysteresis input.

  How many coulombs flow past a given point in the wire

A wire carries a constant current of 607. mA. How many coulombs flow past a given point in the wire in 2.00 sec

  Write a program that reads a file containing only integer

Write a program that reads a file containing only integer, but some of the integers have embedded commas, as in 145,020. The program should copy the information to a new file, removing any commas from the information.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd