Despite the higher expense of three-way valves

Assignment Help Mechanical Engineering

Reference no: EM13718461

Under what circumstances three-way control valves would be used rather than two-way control valves, despite the higher expense of three-way valves?

Reference no: EM13718461

Questions Cloud

Steady-state surface temperature of electrical element : The element of an electrical heating device is a cylinder with a diameter of 12 mm and a length of 20 cm. The electrical energy is dissipated at a rate of 800 W. The air at 20°C moves in a cross flow over the heater with a velocity of 8 m/s.

Determine whether the air flow over the wall is laminar : Air at -5°C flows over the wall of a building with a velocity of 10 m/s. The length of the wall in the direction of air flow is 6 m. The wall is also subjected to a solar insulation of 40 W/m2, and its emissivity is 0.8. Assume an average and constan..

Rate of heat loss from surface of wall due to convection : In a cold winter day, wind blows over the wall of a house at 40 km/h. The outside air temperature is reported to be -7°C. The wall is 8 m long and 5 m height whose surface temperature is 10 °C.

Either brittle fracture or fully plastic yielding is require : A tension member made of 2014-T651 aluminium has a dimensions of b= 30 and t=4mm. A safety factor of 3.0 against failure by either brittle fracture or fully plastic yielding is required.

Despite the higher expense of three-way valves : Under what circumstances three-way control valves would be used rather than two-way control valves, despite the higher expense of three-way valves?

Assume that the cold air standard assumptions applies : The pressure and temperature at the beginning of compression in a Diesel cycle are 100 kPa and 300 K, respectively. At the end of the heat addition, the pressure is 5 MPa and the temperature is 2500 K.

Calculate the specific compressor and turbine work : A simple ideal Brayton cycle has a pressure ratio of 6. The working fluid enters the compressor at a pressure of 100 kPa and a temperature of 300 K. The temperature at the end of the combustion process is 1273 K. applying the cold air-standard assump..

An air-standard otto cycle has a compression ratio : An air-standard Otto cycle has a compression ratio of 6. At the beginning of compression, the pressure is 100 kPa and the temperature is 300 K. During the heating process, the temperature is raised to 2500 K. Assume that the cold air-standard assumpt..

Determine the flow rate of oil through the pipe : Oil at 80°F, density r = 56.8 lbm/ft3 and viscosity m = 0.0278lbm/ft.s is flowing steadily in a 0.5in diameter 120ft long pipe. The pressure at the pipe inlet is 120 psi and at the outlet is 14 psi. Determine the flow rate of oil through the pipe ass..

User Account

All Pages