Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Draw the circuit diagram for the twisted-tail (Johnson) counterconsisting of 4 flip-flops(A, B, C, E) with the following excitation: DA = QE', DB =QA, DC = QB, DE = QC.Assume the flip-flops are cleared initially.1. Obtain the compete state diagram showing both used and unusedstates and transitions. It is a self-correcting design?2. If the design is not self-correcting - modify it to obtain aself-correcting design. Show the work and draw the circuit diagram for the counter withself-correction.3. Design the state decoder which provides a high logic level atonly one output at a time. Draw the circuit diagram for the decoder.
A lossy transmission line at 1GHz has the following characteristics: Z0= 50.0 ohms alpha= 0.01 dB/m, Betta=8 rad/m. Determine R, L, G and C for the line
What is the smallest frequency that can be used to sample each of the following continuous-time signals such that the signal can be recovered from the discrete samples (a) \(x(t)=1+cos(2000\pi t)+cos(4000\pi t)\)
An antenna with a radiation resistance of 48 ohms, a lossresistance of 2 ohms, and a reactance of 50 ohms is connected to agenerator with open-circuit voltage of 10 V and internal impedanceof 50 ohms via a λ/4-long transmission line.
Typically, a speech signal that can be understood over a telephone shows frequencies from about 100 Hz to about 5 KHz. What would the sampling frequency fs (samples/ sec) that would be used to sample a speech without aliasing
Use a modulation index of 50 percent and a sampling rate of 160 kHz. In this project, develop a coherent demodulation for the modulated signal. Assume there is no channel error.
a high power FM station of frequency 96.9 MHz has an antenna height of 1200 feet. If the signal is to be recieved 60 miles from the station, how high does the listener need to mount their anntena in this fringe area
The desired signal at the output of the amplifier is 10 dBm, and the signal level applied to the fiber connector at the head end is 10 dBm. What should the gain of the amplifier be to have 10 dBm at the output of the neighborhood amplifier
Given a fiber optics line between Alaska and Oregon, with a data capacity of 2.5 Gbits/s, calculate the following: a. the number of voice channels (64 kbits/s each) that can be carried on this line b. the number of CDs per second (650 MB each) that c..
Compute the amount of time required to deliver 10 frames to the receiver with stop-and-wait flow control. Assume that all frames and ACKs are received correctly.
A simple power system consists of a dc generator connected to a load center via a transmission line. The load resistance is 8 ohms. The transmission line is 40km copper wire of 4 cm diameter. If the voltage at the load side is 400 V, compute Volta..
Consider the circuit where the value of the inductor is 1H, the initial current in the inductor is iL(0)=-1A and the input source is Vs(t) = 2[u(t)-u(t-1)] and plot the corresponding current in the inductor iL(t) for all times.
Determine the total current supplied by the system and when there is a Y connected capacitor to the bus and the phase impedance of the capacitor is 5 with an angle of -90 degrees (5
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd