Design the pins so that the ledge can support doug

Reference no: EM13545532

Assume the ledge has the dimensions shown and is attached to the building with a series of equally spaved pins around the circumference of the building. Design the pins so that the ledge can support Doug and Jeremy and eight others on each side of the building. Assume each person weighs 200 lbs.

Pin properties: Ultimate shear strength = 100 lb/in^2

Ledge properties: Ultimate shear strength = 200 lb/in^2

Ultimate bearing strength = 300 lb/in^2

Density = 300 lb/ft^3

You must design the pin spacing along the ledge, pin length (in the ledge), pin diameter, and the pin spacing from the top of the ledge. "

Reference no: EM13545532

Questions Cloud

How far upstream is the depth within 100mm : A dam located in a channel of rectangular cross-section which carries water flowing at a rate of 8.75m3/s. The depth of water upstream of the dam is 2.5m

Prepare two pages about photorefractive material : Prepare two pages about photorefractive material with references - Two wave mixing

Evaluate the heat transfer per unit mass and work per unit : A quality of water within a piston-cylinder assembly executes a Carnot power cycle. During isothermal expansion, the water is heated from saturated liquid at 50 bar until it is a saturated vapor. The vapor then expands adiabatically to a pressure of ..

Find the stress induced in the aluminum rod : Find the stress induced in the aluminum rod if, after the gap is closed, the two segments are welded together, and then a leftward force is applied of the same magnitude needed to close the gap. Assume the rod segments remain aligned during loading.

Design the pins so that the ledge can support doug : Assume the ledge has the dimensions shown and is attached to the building with a series of equally spaved pins around the circumference of the building.

Calculate the axial stress in each bar : The bottom bar is made up of an aluminum bar and a steel bar, each 10 in. long placed in the parallel configuration at 70 F. That is also heated to 300 F.

Plot the shear-force and bending-moment diagrams : Plot the shear-force and bending-moment diagrams for the beam and derive equations for the shear force V and the bending moment M for any location in the beam

Estimate the total cost and cost per linear foot for furnush : Estimate the total cost and cost per linear foot for furnushing and driving steel-sheet piling for construction of the basement of a building, 150 by 240 ft. the piles will be 22 in. wide, 18 ft. long, and weigh 40.3 Ib/Lin ft. the piles will be driv..

What is your speed in mph and ft/s need formulas : You are driving a car your metered fuel flow is 5.97x10^5 csf if at the speed you are driving you are getting 40mpg what is your speed in mph and ft/s need formulas.

User Account

All Pages