Reference no: EM13274404
A two-stage counter has two input control lines, M and N. The count sequence is given.
MN sequence
00 0,1,2,3,0...
01 0,1,0,1,0,1...
10 2,0,2,0,2,0....
11 1,2,1,2,1,2....
A) Design the counter assuming the outputs come directly from JK flip-flops.
B) and design the counter assuming a two-stage binary counter is used with the JK flip-flop output decoded
|
Describe the nature of this new image
: A small object is placed to the left of a convex lens and on its optical axis. The object is 30 cm from the lens, which has a focal length of 48 cm. Describe the nature of this new image
|
|
What overall voltage gain gv is realized and peak amplitude
: A CS amplifier utilizes a MOSFET with unCox=400uA/V^2, W/L = 10 and Va = 10V. It is biased at Id = 0.2 mA and uses Rd = 6k Ohm. Find Rin, Avo and Ro. Also, if a load resistance of 10k Ohm is connected to the output
|
|
Develop a tentative thesis
: Develop a few hypotheses about the text that are based on your own perspectives and relate to the topic that you chose to explore for this assignment.
|
|
Find the overall voltage gain gv and also find current gain
: Amplifier with input resistance of 100k Ohm, an open circuit voltage gain of 100 V/V and output resistance of 100k Ohm is connected between a 10k Ohm signal source and 1k Ohm load. Find the overall voltage gain Gv and also find the current gain
|
|
Design the counter assuming the outputs come directly
: A) Design the counter assuming the outputs come directly from JK flip-flops. B) and design the counter assuming a two-stage binary counter is used with the JK flip-flop output decoded
|
|
Find what is the maximum gain for linear operation
: Given two NPN BJTs having β= 100 and ro = 100 Kohm. Using a single 5V dc power supply, design a differential pair amplifier having 1mA bias current in each transistor. What is its maximum gain for linear operation (balanced input, unbalanced outpu..
|
|
What is the temperature inside the furnace
: The blackbody radiation emitted from a furnace peaks at a wavelength of 3.0 10-6 m (0.0000030 m). What is the temperature inside the furnace
|
|
Determine maximum height of a building at centre of path
: The transmitter antenna is to be located on a rooftop at 15 m. The receiver antenna is to be installed at 5 m above ground level. determine the maximum height of a building at the centre of the path if transmitter and receiver antennas are separat..
|
|
Calculate the received power and the path loss
: Calculate the received power and the path loss. Assuming this is the maximum acceptable path loss for the system, how does the maximum system range change at 1 GHz and 10 GHz, assuming all other parameters remain constant
|