Design the circuit with inputs xa-xb-xc and xd-reset l

Assignment Help Electrical Engineering
Reference no: EM13286361

A sequential circuit for a luggage lock has ten pushbuttons labeled 0,1,2,3,4,5,6,7,8 and 9. Each pushbutton 0 through 9 produces a 1 on Xi, i = 0 through 9, respectively, with all other values on variable Xj, j does not equal i, equal to 0. Also, these ten pushbuttons produce a positive pulse on the clock C for clocking the flip-flops in the circuit. The circuitry that produces the Xi signals and the clock C has already been designed. The lock opens in response to a sequence of four Xi values, i = 0, ...9, set by the user. The logic for connecting the four selected Xi values to variables Xa, Xb, Xc, and Xd has also been designed. The circuit is locked and reset to its initial state by pushing pushbutton Lock, which provides L, the asynchronous reset signal for the circuit. The lock is to unlock in response to the sequence Xa, Xb, Xc, Xd, regardless of all past inputs applied to it since it was reset. The circuit has a single Moore type output U which is 1 to unlock the lock, and 0 otherwise. Design the circuit with inputs Xa, Xb, Xc, and Xd, reset L, clock C, and output U. Use a 1-hot code for the state assignment. Implement the circuit with D flip-flops and AND gates, OR gates, and inverters.

Reference no: EM13286361

Questions Cloud

Write program to blink the last 3 digits of security number : Write a program to blink the last 3 digits of your social security number on 3 bits of Port B. For example if the last 3 digits are 654 then bit 2 of Port B should blink 6 times, bit 1 should blink 5 times and bit zero 4 times.
Explain what mass of co2 is produced by the reaction : If a 88.2 gram charcoal briquette (assume pure carbon) is burned in an excess of oxygen, what mass of CO2 is produced by the reaction
The existing required reserves ratio : The Friendly National Bank holds $50 million in reserves atits Federal Reserve District Bank. The required reserves ratio is12 percent.
Estimate the speed of the car : At rest, a car's horn sounds at a frequency of 410 Hz. The horn is sounded while the car is moving down the street. What is the speed of the car
Design the circuit with inputs xa-xb-xc and xd-reset l : A sequential circuit for a luggage lock has ten pushbuttons labeled 0,1,2,3,4,5,6,7,8 and 9. Each pushbutton 0 through 9 produces a 1 on Xi, i = 0 through 9, respectively, with all other values on variable Xj, j does not equal i, equal to 0.
Explain the reaction rate change if is doubled : A reaction in which and react to form products is zero order in , one-half order in , and second order in .By what factor does the reaction rate change if is doubled
What is the default risk premium on corporate bonds : Also, corporate bonds have a 0.25% liquidity premium versus a zero liquidity premium for T-bonds, and the maturity risk premium on both Treasury and corporate 10-year bonds is 1.15%. What is the default risk premium on corporate bonds?
How are the fourier series coefficients cn and dn related : Consider a signal g(t) which is the time-reversed real signal f(t), so g(t) = f(-t). Let g(t) have Fourier series coecients, cn. How are the Fourier series coefficients, cn and dn related
What is the amount of donnas tax liability : What is the amount of Donna's tax liability if the stock is held for 11 months?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is max data rate possible for telephone circuit

What is the maximum data rate possible for a standard telephone circuit with an SNR of 1023 and BW of 3 KHz using 8 bits per symbol

  Calculate the transformation matrix used to rotate an image

(a) Calculate the transformation matrix used to rotate an image by 45o clockwise about the Zaxis. (b) How would you use this transformation matrix to achieve the desired rotation (c) Use the transformation matrix to rotate the image point (x,y) = (0,..

  Design and test a 4-bit ripple carry adder

Design and test a 4-bit ripple carry adder, i. e., an array of 4 full adders, that adds any 4-bit binary number A3A2A1A0 to the 8-4-2-1 BCD code of the third and fourth non-zero and different digits of your Red ID number.

  Find the electrical power delivered to the load in both case

Consider a step-down transformer with 15 turns in the primary and 6 turns in the secondary windings.Calculate the input impedance of this transformer loaded to an 8 O resistor, assuming that series resistances of the windings are negligible.

  Design a circuit that implements thishalf-adder using signal

In a ternary number system there arethree digits : 0, 1, and 2. The figure shown below defines aternary half-adder. Design a circuit that implements thishalf-adder using binary-encoded signals, such that two bits areused for each ternary digit.

  Have to construct algorithm state machine based on details

Given two 8-bit registers, one containing an unknown value and the other used to hold the result of the following operation: - count the number of 1's in the unknown value - signal w=1 starts operation

  Find how high does the ball rise in units of meters

As the ball rises, it gradually loses kinetic energy as its potential energy increases. At the top of its flight, when its vertical speed goes to zero, all of the kinetic energy has been converted into potential energy.

  Compute the speed-output torque and power and stator current

The total friction and core losses may be assumed to be constant at 403 Watts, independent of load. For a slip of 2% , compute the speed, output torque, and power and stator current, power factor and efficiency when the motor is operated at rated ..

  Define various applications for microcontroller-based system

Define an embedded system and how it differs from a microcomputer-based system. Identify various applications for a microcontroller-based designed system.

  Write algorithm to subtract 32 from fahrenheit temperature

Write a main program to call a procedure that converts the Fahrenheit temperature value stored in the location labeled TdegF to its Celsius equivalent. The range of temperatures is 32°F to 212°F. The procedure stores the converted temperature

  Determine ea or offset applicable from addressing modes

Determine the EA or offset, if applicable from the addressing modes(i) Immediate, (ii) Direct, (iii) Register using BX, (iv) registerindirect using BX, (v) Register relative using BX, (vi) Basedindexed, and (vii) Based indexed relative.

  Determine vaulters altitude as vaulter crosses the bar

A 52-kg pole vaulter running at 12 m/s vaults over the bar. Her speed when she is above the bar is 0.7 m/s. Neglect air resistance, as well as any energy absorbed by the pole, and determine her altitude as she crosses the bar.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd