Design pcm system that converts analog to digital signal

Assignment Help Electrical Engineering
Reference no: EM13275853

design a PCM system that converts an analog signal to digital signal. specify the sampling frequency and the number of quantization levels you pick. Requirement:

A.) the signal to quantization noise ratio must be higher than 57 dB.

b.) supper the analog signal is sampled and quantized for 1 minute. Then the PCM output must fit into a storage space of 840 bytes.

Reference no: EM13275853

Questions Cloud

Determine the power output of this engine : An engine draws energy from a hot reservoir with a temperature of 1250 K and exhausts energy into a cold reservoir with a temperature of 355 K. What is the power output of this engine
What is the energy storage capacity of the battery : A certain 12V dry-cell battery, completly discharged, requires a current of 100mA for 1 hour to completely recharge. What is the energy storage capacity of the battery (in kJ), assuming the voltage does not depend on its chage status.
Explain what are the electronic configurations of pb and pb2 : what are the electronic configurations of Pb and Pb2+, also Mo and Mo2+. please explain what are their valence electrons.
What percent of the initial energy of the bullet was lost : Three blocks (1,2,3) of mass 3.00 kg, 2.00 kg, 1.00 kg sit linearly 10.0 cm apart from each other on a frictionless surface. What percent of the initial energy of the bullet was lost
Design pcm system that converts analog to digital signal : design a PCM system that converts an analog signal to digital signal. specify the sampling frequency and the number of quantization levels you pick. the signal to quantization noise ratio must be higher than 57 dB.
Explain cool to the final temp at constant volume : Cool to the final temp at constant volume and then expand to the final pressure at constant temperature. Calculate the work done for each path.
How high does the rocket travel : A model rocket is fired vertically from rest. It has a net acceleration of 15.0 m/s2. After 1.1 s, its fuel is exhausted and its only acceleration is that due to gravity. how high does the rocket travel
What is basket weaver weighted average cost of capital : The corporate tax rate is 34 percent. What is Basket Weaver's weighted average cost of capital?
Find stall speed : Find Stall Speed (KEAS) at 1 G, 0 deg AOB and find Stall Speed (KEAS), level flight 70 deg AOB (2.9 G)

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Design a 3 rd order high - pass butterworth filter

Design a 3 th order high - pass Butterworth filter with a High Frequency gain of 20 DB and a cutoff frequency of 20 rad/s. 2) Using MATLAB, plot the frequency respon se of this filter, and the location of the filter poles.

  Draw an equivalent circuit representing each of power system

Draw an equivalent circuit representing each of the following power system components, showing all the circuit parameters in each case: (i) Short transmission line (ii) Medium length transmission line (pi and T circuits) (iii) Synchronous generator

  Determine the conductivity of silicon at t

Determine the conductivity of silicon at T = 300 K if it is doped with donor impurity atoms at a concentration of 1.25*1016 cm-3. Assume that the electron and hole mobilities are 1350 cm2 / V-s and 480 cm2 / V-s, respectively.

  Determine what is the output power in watts

A given device has been determined that it attenuates 4.8dB in power from its input terminal to its output terminal. What is the output power in watts if a 150-W input has been launched into a system that has two of this type of devices

  Find how many kilobytes of memory are there on the chip

If memory on a single memory chip ranges from address 100000H to 8FFFFH, how many kilobytes of memory are there on this chip if the memory is byte addressable

  Find all values of alpha such that the system is stable

Find all values of alpha such that the system is stable for K = 2. If the unity feedback closes around this G(s) and an input is a unit step r(t) = 1u(t), what is the stead-state error, e_ss, as a function of alpha and K?

  Design a short circuit stub matching circuit to match load

(a) ZL = 80+j60 , what is the load reflection coecient. (b) Design a short circuit stub matching circuit to match the load to Z0 of 50-ohms. State the distances in wavelengths and in centimeters.

  How to determine that the load is delta connecteg

Delta load Assume that the load is delta connected. Each phase has a series RL load with R = 5 ohms and L = 20 mH. Plot the phase to phase voltage (Vab) versus time for one cycle. Hint: Vab = Va - Vb

  What is the value of gm for each of the two transistors

If Vid is 20-mV peak-to-peak sine wave applied in a balanced manner but superimposed on Vcm = 0.5 V, what is the lowest value that Vdd must have to ensure saturation -mode for Q1 and Q2 at all times. Assume Vt = 0.5 V.

  Depiction impedance diagrams

Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.

  What senses 3 accelerometer readings into pins

Write C code that senses 3 accelerometer readings into pins PAD 8, 9 and 10 and displays them on the LCD. Also run a timer in seconds and log the values of the accelerometers in 3 arrays every second.

  How hot would a conventional pipe have to get to burst

How hot would a conventional pipe have to get to burst and why. Does it vary according to what material the pipe is made of. Which are the strongest. What are weak ones

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd