Design frequency divider cicuit that will produce the output

Assignment Help Electrical Engineering
Reference no: EM13291801

Design a frequency divider cicuit that will produce the following three ouput signal frequencies: 1 MHz. 800 kHz, and 100 kHz. Use 74HC160 and 74HC161 counter chips and any necessary gates. The input frequency is 12 MHz.

Reference no: EM13291801

Questions Cloud

Determine the initial speed of the apple : An archer shoots an arrow with a velocity of47.5m/s at an angle of50.5° with the horizontal. What is the initial speed of the apple
Explain the equilibrium concentration of chloroacetic acid : What is the equilibrium concentration of chloroacetic acid, HC2H2O2Cl, in a solution prepared by dissolving 0.0277 mol of HC2H2O2Cl in 1.00 L of water
Design a combinational circuit that compares two 4-bit num : Design a combinational circuit that compares two 4-bit numbers to check if they are equal. The circuit output is equal to 1 if thetwo numbers are equal and otherwise 0.
Find the maximum current induced in the coil : An AC generator is to have a maximum output of 318 V. Each coil has an area of 0.145 m2 and a resistance of 15.7 ?, Find the maximum current induced in the coil
Design frequency divider cicuit that will produce the output : Design a frequency divider cicuit that will produce the following three ouput signal frequencies: 1 MHz. 800 kHz, and 100 kHz. Use 74HC160 and 74HC161 counter chips and any necessary gates. The input frequency is 12 MHz.
Develop johnston market value based capital structure : Develop Johnston's market value based capital structure, and calculate its WACC. Assume equity capital comes from retained earnings, and the marginal tax rate is 40%.
Determine the induced emf and current as functions of time : An AC generator consists of eight turns of wire, each having area A = 0.0890 m2, with a total resistance of 11.4 ?. Determine the induced emf and current as functions of time
What is the smallest possible load resistor that can be used : Design a 7.5V zener regulator circuit using a 7.5V zener specifiedat 10mA. The zener has an incremental resistancerz=30Ω and a knee current of 0.5mA. Theregulator operates from a 10V supply and has a 1.2kΩ load. What is the value of R you have cho..
Determine the emf induced in the rod : Suppose the current suddenly increases to 1.55 A in the same direction as before, due to an increase in speed of the bar. Find the emf induced in the rod

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Design a moore sequential machine that has one input x

Design a Moore sequential machine that has one input X and one output Y. Whenever X changes from 0 to 1, Y should become 1 for two clock cycles and then return to 0 - even if X is still 1. For example, given an input sequence X=0110101001.

  What is the maximum number-nc of users that can be supported

Suppose that a 5 Mbps link is being shared by a number of users. Each user alternates between period of activity during which the user  transmits at rate 1 Mbps and periods of silence, when the user does not transmit.

  What happens when an ac supply is given to a dc machine

1) Which has greater efficiency DC Machine operating as MOTOR or GENERATOR  2) What happens when an AC supply is given to a DC Machine

  Find what is the magnitude of the magnetic field

The torque produced by an external magnetic field is torque = D[5i,-3j] where D is a positive constant, and for this orientation of the loop the magnetic potential energy U = -mu cross B is negative. The magnitude of the magnetic field is 14D/IA

  Find general expression for best estimate of x of function

A random signal X can be observed only in the presence of independent addictive noise N. The observed quantity is Y = X + N.The joint probability density function of X and Y is f(x,y) = K exp[-(x2 + y2 + 4xy)] all x and y

  What current will flow in diode if the forward voltage bias

a) What current will flow in the diode if the forward voltage bias is raised to 0.8V b) What current will flow in the diode if the forward voltage bias is lowered to 0.6V c) What change in forward bias voltage will increase the diode current by a ..

  Calculate the equivalent series impedance of the transformer

The nameplate on a 25-MVA, 60-Hz single-phase transformer indicates that it has a voltage rating of 8.0-kV:78-kV. A short-circuit test from the high-voltage side (low-voltage winding short circuited) gives readings of 4.53 kV, 321 A, and 77.5 kW.

  Evaluate the discrete fourier transform of sequence

given a sequence x(n), where x(0) = 4, x(1) =3, x(2) = 2, and x(3) =1 with the last two data zero-padded as x(4) =0, and x(5) = 0, evaluate its DFT x(k)

  What condition is relation in na-nd nd no good approximation

Compensation occurs when a semiconductor is doped with both donor and acceptor dopants. Using the fact that n0p0=ni^2 (mass action law) and p0+Nd=n0+Na (charge neutrality assuming all dopants are ionized)

  What is the maximum closed-loop voltage gain obtained

An audio amplifier system, using a noinverting op-amp circuit, needs to have a small-signal bandwidth of 20kHz. The open-loop low-frequency voltage gain of the op-amp is 10^5 and the unity -gain bandwidth is 1 MHz.

  Find real and reactive power supplied to the 360-v winding

1-phase 2-winding transformer is rated 30 kVA, 360/90 V, 60 Hz. A source connected to the 360-V winding supplies an impedance load connected to the 120-V winding. The load absorbs 15 kVA at 0.8 p.f.

  Find closed form expressions for and graph system response y

Given the excitations x[n] and the impulse responses h[n], find closed form expressions for and graph the system responses y[n] x[n] = u[n], h[n]=(4/7)δ[n]-(-3/4)nu[n]

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd