Design common drain amplifier that can couple signal source

Assignment Help Electrical Engineering
Reference no: EM13274917

Design a common drain amplifier that can couple the signal source to the load to make this possible. You may use some or all of these:
a) one +9V DC supply
b) NMOS transistors with Vt=1V, k'n =20µA/v2, ?=0, L=1µm, and combined W of all transistors not to exceed 6000µm
c) one ideal current source of value 10mA that pours current down from the +9V terminal

d) capacitors and resistors

A signal source produces a 4 volt peak-to-peak sinusoid and has a source resistance of 100 ohms. We wish to drive a grounded 10 ohm load to at least 2 volts peak-to-peak with this source. The load cannot tolerate DC.
Your amplifier should not burn more than 2 watts while idle, and must pass signals above 100 Hz.
Make sure that no transistor in your amplifier leaves the saturation region while driving the load.

Reference no: EM13274917

Questions Cloud

What max heigh above the ground does the ball reach : A football is kicked from ground level and lands 57.0 m downfield. What max heigh above the ground does the ball reach
Lead to a bigger firm and a greater market concentration. : A merger will lead to a bigger firm and a greater market concentration.
What is the value of the straight-debt portion of the bonds : There are 30 warrants attached to each bond, which have a par value of $1,000. What is the value of the straight-debt portion of the bonds?
Explain heat generated by a car engine as it burns gasoline : Choose all of the processes from below which describe changes which are independent of the path by which the change occurs. the elevation increase experienced by a traveller travelling from Grand Isle, LA to Denver, Colorado
Design common drain amplifier that can couple signal source : A signal source produces a 4 volt peak-to-peak sinusoid and has a source resistance of 100 ohms. We wish to drive a grounded 10 ohm load to at least 2 volts peak-to-peak with this source. The load cannot tolerate DC. Your amplifier should not burn..
What coupon rate should be set on the bonds-with-warrants : A similar straight-debt issue would require a 10% coupon. What coupon rate should be set on the bonds-with-warrants so that the package would sell for $1,000?
How long did it take for the sound to travel to rodrigues : The huge volcanic eruption on the island of Krakatoa, Indonesia, in 1883 was heard on Rodrigues Island, How long did it take (in seconds) for the sound to travel to Rodrigues
What minimum yearly cash inflow will be necessary : what minimum yearly cash inflow will be necessary for the company to go forward with this project? b. How would the minimum yearly cash inflow change if the company required a 10% return on its investment?
Pentose sugars in living organisms : Explain the function of triose and pentose sugars in living organisms

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the surface charge density on the inner shell

Concentric spherical conducting shells in free space of radii r1 = 0.00113 m and r2 = 0.00220 m have a potential difference of 20.0 V (let the inner shell be at 0 V and the outer shell be at 20.0 V).

  Distinguish the synchronization sequence

Suppose that the sequence 110010011 is used as a synchronization sequence preamble to a data packet. Propose a method that can be used to allow the channel to distinguish the synchronization sequence from an identical data sequence within the pack..

  Explain why capacitive reactance is measured in ohms

Discuss why it is that for a discharging capacitor, the discharge current is in the direction opposite from the charging current. Explain why capacitive reactance is measured in ohms. Also, state two differences between capacitance and capacitive r..

  Find how many different choices of officers are possible

A president, secretary, and treasurer are to be chosen from a group of 10 senior members of the IEEE student chapter at the Citadel. Assume that each member cannot serve more than one position.

  What would be the relative error expressed in percent

The doping level of N-type semiconductor is Nd= 5^19 cm^-3. Determine the room tempature position of the Fermi level ( with respect to the bottom of the comduction band) if the semiconductor is A). Si (Nc=2.86^19cm^-3)

  How much time passes before the players collide

Two soccer players start from rest, 34 m apart. They run directly toward each other, both players accelerating. The first player's acceleration has a magnitude of 0.42 m/s2. The second player's acceleration has a magnitude of 0.41 m/s2.

  Find the required x-y coordinates of a 20-nc fourth charge

Three point charges are positioned in the x-y plane as follows: 5 nC at y = 5 cm, -10 nC at y = -5 cm, and 15 nC at x = -5 cm. Find the required x-y coordinates of a 20-nC fourth charge that will produce a zero electric field at the origin.

  Find the total current and voltage across capacitor

A voltage source V(t)=100cos(6Π109t - 45(degrees))(V) is connected to a series RLC circuit. If R = 10MΩ, C = 100pF, and L = 1H, use phasor notation to find the following: a.) i(t) b.) Vc(t) (voltage across capacitor)

  Why does the mobile carrier concentration increases

b) What are the equilibrium electron and hole concentrations at 300K and 500K (hint: You will have to find Nc and Nv at 500K, but it isnt necessary for 300K) c) Why does the mobile carrier concentration increase at high temperatures

  Calculate the response of each of the receiver arms to qpsk

First draw the transmit con-stellation and the receive constellation with ideal phase tracking and sampling. Note:they are obviously the same constellations. Now, assume that receiver synchronization is off by a phase angle.

  Calculate the three-phase steady-state short-circuit current

A 150 MVA, 24 kV, 123% three-phase synchronous generator operates with an induced voltage that is twice the rated line-to-neutral voltage. Calculate the three-phase steady-state short-circuit current at the generator terminals.

  What total charge is contained within a cylinder of radius a

An electric flux density is given by D = D0 a, where D0 is a given constant. (a) What charge density generates this field (b) For the specified field, what total charge is contained within a cylinder of radius a and height b

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd