Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A liquid level system converts a 4-10 m level into a 4-20mA current. Design a three mode controller (PID im assuming) that outputs 0-5 volts with 50% PB, 0.03 min integration time, and 0.05 min derivative time. Fastest expected change time is 0.8 minutes.
Calculate the approximate quantization S/N ratio in the baseband audio signal at the receiver output (after the DAC and LPF).
a. Design a 3 bit combinational circuit 2's complimenter. (the circuit generates the 2's compliment of the input 3-bit binary number). [Show all work leading to the circuit implementation]
assuming XTAL=11.0592 MHz,write a program to genrate a square wave of 20 Hz frequency on pin2.3?
1. What is the effect of sampling at a higher rate on the error performance of a digital modulation scheme 2. Suppose 16QAM was the modulation scheme used for this lab; would the error performance
In order to eliminate the cost of calling cards, the company in the above problem is considering a new policy that requires blocked callers to redial over and over until they get a trunk.
Sketching the Dependence of l versus h on Cartesian Axes, The distance l from a point at a height h above the Earth's surface to the horizon can be approximated using Pythagoras theorem by the expression:
Design four by four combinational binary multiplier using hierarchical design method, use switches as inputs, use LEDs as outputs, download design on FPGA and show your demo. You must design this part in VHDL.
The bellows, diaphragm, and Bourdon tube pressure sensors all exhibit second order time response. This means that a sudden change in pressure will cause an oscillation in the displacement and, therefore in the sensor output.
Tuning methods for PID controllers, Investigating tuning methods for PID controllers of 2nd order and 3rd order control systems. Eg. Zieglar Nichols, etc
Based on these equations, determine the maximum power point. This is the value of and T that result in maximum power. State the power and the (,T) values. Do not assume this happens at 0.5T. The best way to do this is to make an Excel spreadsheet.
Determine the surface charge density on each conductor.
Design a DC current source to meet the following specifications: - Current source value: 100 u-amps +/- 1% (over all possible load and supply voltage conditions). - Output resistance: >20 Mohms. - Available DC voltage sources are bipolar and range fr..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd