Design a linkage to carry the body

Assignment Help Mechanical Engineering

Reference no: EM131393053

Design a linkage to carry the body in Figure P5-1 through the two positions P1 and P2 at the angles shows in the figure. Use analytical synthesis without regard for the fixed pivots shown.

Design a linkage to carry the body in Figure P5-l through the two positions P2 and P3 at the angles shown in the figure. Use analytical synthesis without regard for the fixed pivots shown.

Reference no: EM131393053

Questions Cloud

Design a two alarm system turning on one led : A type-J TC with a reference monitors a process temperature. Design a two alarm system turning on one LED at 100°C and another at 150°C.

Develop signal conditioning and error detection : Develop signal conditioning, error detection, and a PI controller for the following specifications: 0-300-psi measurement range; setpoint adjustable from 100 to 200 psi; K,, adjustable from 1.5 to 5.0; K1 switchable between 0.8, 1.6, 2.4, and 3.2 ..

Evaluate corporations international business-level strategy : For the corporation that operates internationally, briefly evaluate its international business-level strategy and international corporate-level strategy and make recommendations for improvement.

Design a proportional controller : Design a proportional controller for a 4- to 20-mA, ground-based input, a 0- to 9-V output, zero-error output adjustable from 0 to 100%, and K4, adjustable from 1 to 10. Design so the setpoint can be selected in the range of 4 to 20 mA.

Design a linkage to carry the body : Design a linkage to carry the body in Figure P5-l through the two positions P2 and P3 at the angles shown in the figure. Use analytical synthesis without regard for the fixed pivots shown.

Design a three mode controller : A liquid-level system converts a 4-10-m level into a 4- to 20-mA current. Design a three-mode controller that outputs 0-5 V with a 50% PB, 0.03-min reset time, and 0.05-min derivative time.

Calculate and plot the x and y components : For the walking beam mechanism of Figure P4-9, calculate and plot the x and y components of the position of the coupler point P for one complete revolution of the crank O2A.

Design a three mode controller : Design a three-mode controller that outputs 0-5 V with a 50% PB, 0.03-min reset time, and 0.05-min derivative time. Fastest expected change time is 0.8 min.

Produce the minimal cut sets for tree : Silversands Lifts (SL) are building a new design of computer controlled lift. Produce the minimal cut sets for this tree. Explain how you would use fault trees to address analysis of systematic failures. Illustrate using the fault trees presented in..

User Account

All Pages