Design a four-section che by shev matching transformer

Assignment Help Electrical Engineering
Reference no: EM131105376

Design a four-section Che by shev matching transformer to match a 50 Ω line to a 30 Ω load. The maximum permissible SWR over the pass band is 1.25. What is the resulting bandwidth? Use the approximate theory developed in the text, as opposed to the tables. Use CAD to plot the input SWR versus frequency.

Reference no: EM131105376

Questions Cloud

What amount of accrued liability : After the 2011 financial statements were issued, Haft received and accepted an IRS settlement offer of $275,000. What amount of accrued liability should Haft have reported in its December 31, 2011 balance sheet?
Explain rationale for the use of the lower-of-cost-or-market : Explain the rationale for the use of the lower-of-cost-or-market rule as it applies to inventories. Determine the proper balance in Allowance to Reduce Inventory to Market at May 31, 2014.
What amount of loss should dunn accrue : Dunn's accounting year ends on December 31, and the 2011 financial statements were issued on March 2, 2012. What amount of loss should Dunn accrue at December 31, 2011?
Compute the value of pet food company bonds : Pet Food Company bonds pay an annual coupon rate of 10.59 percent. Coupon payments are paid semiannually. Bonds have 24 years to maturity and par value of $1,000. Compute the value of Pet Food Company bonds if the market interest rate on this type..
Design a four-section che by shev matching transformer : What is the resulting bandwidth? Use the approximate theory developed in the text, as opposed to the tables. Use CAD to plot the input SWR versus frequency.
Examples of money market or capital market securities : Indicate whether the following instruments are examples of money market or capital market securities.a. U.S. Treasury bills b. Long-term corporate bonds c. Common stocks d. Preferred stocks e. Dealer commercial paper
What is the depreciation expense for year 1 : The company uses the straight-line method of depreciation. Under IFRS, what is the depreciation expense for year 1?
Was he entitled to specific performance : Ruth and Stella were sisters. They owned a house as joint tenants with right of survivorship. Ruth sold her half interest to Roy. Thereafter, Stella died, and Roy claimed the entire property by survivorship. Was he entitled to it?
Calculate the bond price today : General Mills has a $1,000 par value, 11-year to maturity bond outstanding with an annual coupon rate of 8.17 percent per year, paid semiannually. Market interest rates on similar bonds are 12.31 percent. Calculate the bond's price today.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate the current that flows in the remaining two

Three 5 ohm resistors are connected in wye across a 3-phase,480V line. Calculate the current flowing in each. If one of the resistors is disconnected, calculate the current that flows in the remaining two.

  Calculate the normal force fn for 300 g and 150 g

Assume the mass of the cup and water to be equal to the mass of water alone. Calculate the normal force FN for 300 g and 150 g.

  How much voltage is assumed dropped across a diode

(1) If you have a transformer that is not in a circuit, how can you tell/determine what the ratio is (2) How do you tell if a diode is forward or bias. How much voltage is assumed dropped across a forward biased silicon diode.

  Determine needed values for rx

You must work the problem and also find the results using any of the available software (Mutisim, PSpice, Proteus, etc.) You will be asked to explain your results in next Class meeting (oral explanation).

  Find the average power dissipated on the resistor in mw

A square pulse train (i.e. square wave) with low and high voltage values of VL= 0 and VH= 2.9 volts is applied to a DC voltmeter. The voltage measured by the instrument is 0.2 volts. The same signal is applied to an 99 O resistor.

  Question 1the matlab file psa9p12m should be used for this

question 1the matlab file psa9p12.m should be used for this question.loads at peak timebus 2nbsp 100 mw 0 mvar bus 3

  Parallel versus in series

How do resistors add in parallel versus in series? How do capacitors add in parallel versus in series? Are they different?

  Determine the armature current and speed

A 300 V, 60 A, 1200 rpm series dc motor has an armature and series field resistance of .2 ohms each. When a .10 ohm resistance is connected in parallel to the winding, the motor's torque is doubled.

  Show that for a square matrics the linear dependence row

show that for a square matrics the linear dependence of the row vectors imples the column vectors.conversely for a non square matrics either row vectors or column vectors are linear dependent.

  What are earnings as a percentage of the final retail price

In the electronics business, mark-up is in the order of 100% to 130% at each level of middleman. Let's say that it is 100%. Let's further say that your product passes through three levels of middleman, that your product is produced in accordance

  Describe how would design a gray code counter without vhdl

Explain why the low value (0) for the 'output' of a digital logic gate is lower than the low value for the 'input' of a digital logic gate (This is the case for CMOS and Bipolar logic). Look at a specsheet.

  Write general form of natural response for capacitor voltage

Consider a source-free parallel RLC circuit having alpha =10^8 s^-1, omega-sub-zero = 10^3 rad/s, and omega-sub-zero * L = 5 ohm. a) Show that the stated units of omega-sub-zero * L are correct. b) Compute s_1and s_2.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd