Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Design a filter that satisfies the following requirements:1 input is a current source ranging from 4 mA to 20 mA with a source resistance of 10 ohms.2 THe filter must output a voltage ranging from 2v to 10 v.3 The filter must suppress 60 hz noise with a minimum Q=504 The filter must also reject high frequency noise above 10 khz with a minimum roll- off in the stopband of -70 dB/dec5 Available power supply +- 15 v.
You may assume that op amps are ideal except that the op amps saturate at +- 13 v. There are no limits in terms of cost or the number of components you may use. You can use any topology.
Find the imaginary part of e^ - (j pi)/2 Find the magnitude of e^ jtheta (for any real value of theta) Find the magnitude of Ae^( j theta) (for any real values of A and theta) Find the phase of -5j in radians
Let X denote the number of accepted circuits. Let Y be a random variable which is 1 if the last (Nth ) IC was accepted and is zero otherwise (it is a Bernoulli random variable). (a) Write out the probability mass function (PMF) of X.
The resistance of the coil is 0.2 ohm. The inductance of the coil is 1.2e-4 H. The rotor inertia is 1.0e-5 kg m2. The current to torque gain is 0.03 Nm/A. The friction torque is 0.09 Nm. A 12 V voltage source is applied to the motor.
The surface concentration is fixed at N0=1.8e20/cm^2 when diffusing boron into a uniformly doped n-type substrate. The atomic diffusion constant for boron in Si at the temperature of 950 C is 3.0e-15 cm^2/s.
Analyzing the Blink Alive code - Embedded Systems Design
A 200-MHz voltage source with output Vg = 200 V 0 and internal impedance of 100 Ω is connected to the input of the line. Determine the time-dependent voltage and current at the load, and the average power delivered to the load.
1)Convert the binary number (0.1000)2 to decimal. 2)The number (17)10 represented as an unsigned, 6-bit binary number is 3)The number (-25)10 in 6-bit sign magnitude format is 4)The number (32)10 in 6-bit 2's complement is
Single pole amp. has an open loop gain 10^6 and open loop bandwidth of 10Hz. If the feedback factor =1, calculate the gain and bandwidth after the feedback
A 1 kHz sine wave signal with a power level -10 dBm is applied to the input of the amplifier. What is the power at the amplifier output in dBW?
What is the (approximate) maximum electric field intensity for which constant mobility may be assumed for electrons in silicon In a digital circuit with a supply voltage of 1V, what is the corresponding gate length for MOS transistors
Calculate the minimum PWM frequency for a small permanent magnet DC motor with a time constant of 15 milliseconds.
2. Design an amplifier with a gain of 2 using Multisim. 3. What is the phase shift between the input and output signals of an inverting op amp 4. What is the phase shift between the input and output signals of a non- inverting op amp
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd