Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Design a discrete time Echo filter in order to process the demo signal Splat, using Fs = 8192 Hz. The filter should pass the original signal unchanged and the first echo should be located at 0.7 seconds with 10% attenuation and the second echo should be located at 1.2 seconds with 20 % attenuation.
Find the filter unit sample response in terms of delayed unit samples: h[n]
A solar pond consists of a thin layer of fresh water floating on top of a denser layer of salt water. When the salty layer absorbs sunlight it warms up and much of that heat is held there by the insulating effect of the fresh water above it
three balanced Y-connected loads are installed on a balance three phase four-wire system load 1 draws a total power of 6kw at unity P.F load 2 requires 10 KVA at P.F=0.96 lagging load 3 needs 8kw at 0.85 lagging if the phase voltage is 135V
An inverting amplifier with resistors R1= 5.6k and R2=120K is fabricated using an op amp with an open loop gain of 10^5. What is the percent difference between the actual gain and the ideal gain
A series-resonant RLC circuit has R = 80 (ohms), L=25mh, and C=10pF. A) Sketch and label the circuit. B) Find fo, the resonant frequency. C) At what frequency is impedance a minimum D) What is the magnitude of the impedance at this frequency
The work-piece motion of a certain system is measured using an LVDT that outputs 12mV/cm. (i) If the output from the LVDT ranges from -12mV to 24mV, what is the maximum horizontal motion of the work-piece motion
A three resistors connected in series with a DC power supply of 12 volts with a return path to the negative terminal of the power supply also connected to ground. The first resistor is labeled "R1", which is equal to 220 Ohms.
A Y-connected three phase supply has a balanced voltages of 110e^j0, 110e^(j2/3) and , 110e^(j4/3). The corresponding impedances on the Y-connected load are 30, 30+j40 and 40+j30 ohm.
1- Why do we use PWMCTL What does it mean If we have PWMCTL=0x80 What does it mean if we have PWMCTL = 0x00 2- The PWMPER register and PWMDTY registers are 8 bits. What does it mean when we say we are using a 16-bit PWM
Sizes are given as the diameter of the pizza in inches. The cost of a pizza is based on the size. Bob would like to know which size of pizza has the lowest cost per square inch. a. Identify the inputs and outputs for this problem.
a single span of an overhead line is 250 ft in length, having the supporting poles at the same level. the maximum tension in the conductor is 855 lb. the weight of conductor is 0.125 lb/ft.
A continuous time system, described by y(t) = 5 Cos (2*pi*20*t + pi/2), is sampled at a rate 320 Hz. (a) Write the mathematical expression that describes the discrete time (sampled) signal. (b) Calculate the value of the discrete signal for n = ..
Multiple charges at different locations are said to be in equilibrium if the force acting on any one of them is identical in magnitude and direction to the force acting on any of the others. Suppose we have two negative charges
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd