Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A circuits is needed to realize the transfer function \(T_{v}(s)=\pm \frac{(s+125)(s+500)}{(s+250)(s+1000)}\) (a) Design a circuit using two OP AMPs(b) Design a circuit using only one OP AMP.(c) Design a circuit using no OP AMPS.In all cases, scale the circuit so that all parts use practical values
A mote draws an average of 200mA when "awake", 0.1mA when "sleeping", and 400mA (total) when "transmitting". Transmitting data takes 2ms, and sensor acquisition takes 1ms. If the maximum size battery available is 5000mAh
Design a DC power supply that provides -95v +/- 5v to a 2 amp load (energy absorber). The input source is a 100 volt peak sinusoid, 60 Hz. You may use any basic circuit element. State the values of all circuit elements (in ohms, farads, etc).
Bill will have an adjusted gross income this year of $70,000. Valerie has an adjusted gross income of $1500 a month. Bill and Valerie have agreed that Valerie should continue working only until the federal income tax on their joint income tax retu..
Design a 16 bit adder using both the ripple carry and CLA methods. Use 4-bit CLA blocks for the carry-lookahead design. Use only two-input logic gates in your design. Simulate the design using LogiSim at the logic gate level.
A 10m diameter cylindrical tank is emptied by a constant outflow of 1 m3 /min. A two position controller is used to open and close a fill valve with an open flow of 3 m3 /min. For level control the neutral zone is 1m and the setpoint is 10m.
A telephone line has the following parameters: R = 40 W/m, G = 400 mS/m, L = 0.2 mH/m, C = 0.5 nF/m. (a) If the line operates at 10 MHz, calculate the characteristic impedance Zo and velocity u,
How are the left (L) and right (R) signals obtained separately in the radio receiver to drive the dual channel audio amplifier and speakers?
An n-channel JFET needs a NEGATIVE voltage applied to its GATE, relative to its SOURCE. If you have a single POSITIVE supply applied to the MASTER loop of a JFET, the mid point of the voltage divider will also be a positive voltage
Discuss the sequence of actions that occur in the operation of the control system for a traffic light, that includes sensors in the roadbed. Indicate which actions are time-driven and which actions are event-driven
First you must give all different possible connection types for them and then, for each case, you should develop some tests that can define the connection type and calculate the current passing through the capacitors.
an unknown semiconductor has Eg=1.1ev and Nv=Nc.it is doped with 10^15 donors,where the donor level is 0.2ev below Ec. given that Ef is 0.25ev below Ec, calculate ni and the concentration of electrons and holes in the semiconductor at 300k.
Design a second-order band-pass filter for a system with sampling frequency of 18 kHz that is tuned for f=5kHZ The filter should not have any sample delay (the numerator and denominator orders are equal)
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd