Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Design a basic pacemaker circuit in PSPICE/LTSPICE using a 555 timer, switching transistor and a RC pulse output circuit. Report your design, schematic, input and output waveforms and design rationale.
Write a program that uses the rand_float functions developed to generating sequences of random floating-point values between 4 and 10. Then compare the computed mean and variance to the theoretical values computed.
Sketch a graph of the drain-source current, IDS, as a function of drain-source voltage, VDS, for an enhancement-mode NMOS transistor with a threshold voltage of 1 V. On the same graph indicate how this curve would be shifted for a depletion-mode N..
Suppose station A and B are interconnected through two parallel unreliable links, where each link has a failure probability of 0.1. Calculate the average seconds per day when A and B lose communication.
Calculate the minimum PWM frequency for a small permanent magnet DC motor with a time constant of 15 milliseconds.
You have a laundry room where the following loads are connected to a 208V circuit: 2500W electric base board heater, 600W wash machine, 3600W dryer, and a 1000W iron. All loads are connected in parallel.
a 14-bit successive approximation adc is used to sample a signal that has a full-scale range of 8V and a clock frequency of 12 MHz and a jitter of 50ns.initially this is used without a sample and hold amplifier.
Calculate the percentage second harmonic distortion present in the output. Calculate the percentage error in the output voltage compared to its ideal value at the instant of time when t= 1/3200 seconds.
Indicate the use of each memory in the microcontroller (HCS12). In other words, state which one is used for code, program variables, and variables that must remain when the power is turned off.
Wires manufactured for use in a computer system are specified to hve resistances between .12 and .14 ohms. The actual measured resistances of the wires produced by company A have a normal probability distribution with mean .11 ohm
It is required to use a peak rectifier to design a dc power supply that provides an average dc output voltage of 15 V on which a maximum of 1-V ripple is allowed. The rectifier feeds a load of 150 ohm.
Can A Buck Converter with Synchronous rectifier operate in DCM at a light load. If the load is disconnected how does this affect the Inductor current.
A coil of 10H inductance and 5Ω resistance is connected in parallel with a 20Ω resistor across a 100-V DC supply which is suddenly disconnected. Find The voltage across the 20Ω resistor initially and after 0.3 sec.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd