Design a 4-bit counter f using d-flip flop

Assignment Help Electrical Engineering
Reference no: EM13227871

design a 4-bit counter F( represented by F3,F2,F1,F0) which can count the specified sequence as following: 0000->1000->1111->0110->0000. The counter will use the falling edge of the clock (denoted by Clk) and have a separte reset pin (R) which will reset the counnter to 0000 when it is low (e.g. R=0). Please use D type flip-flops. write down the state diagram , and state table ; use K- map to simpify the input equations; Write down the simplified input equations and draw a neat circuit diagram.

Reference no: EM13227871

Questions Cloud

Compute enthalpy for the reaction 2no : At 298, 1 atm, the heat produced by the reaction of 4.00mol of NO with molecular oxygen heats 1.07L liquid water from 298k to 348k. Calculate enthalpy for the reaction 2NO + O2 -> NO2, at 298k. Assume constant pressure and no heat lost.
What are the issues managment of starbucks needs : What are the issues managment of Starbucks needs to address? Analyze and evaluate the issues identified. Recommend a set of actions management should take to address the issues that have been identified and analyze them.
Identify the challenges faced by front-line employees : Discuss how front-line employees are critical to customer assessment of service quality. Identify the challenges faced by front-line employees.
Compute the pressure of the gas : A sample of Chlorine gas occupies a colume of 711 mL at pressure of 251 mmHg. Calculate the pressure of the gas (in mmHg) if the volume is reduced at constant temperature to 173 mL in scientific notation
Design a 4-bit counter f using d-flip flop : The counter will use the falling edge of the clock (denoted by Clk) and have a separte reset pin (R) which will reset the counnter to 0000 when it is low (e.g. R=0). Please use D type flip-flops. write down the state diagram , and state table.
Select one of panera breads competitors : Select one of panera Bread's competitors and discuss a disadvantage that panera has with the competitor and how this disadvantage may be overcome.
Describe the eight general strategies in the business buying : Describe the eight general strategies in the business buying decision process.
Depict and label the galvanic cell : Draw and label the galvanic cell, then write and identify he two half-life reactions and write the overall cell reaction. Calculate E. Write the cell diagram for the galvanic cell and calculate the expected cell potential
Determine a linear trend line for expected freight car : Determine a linear trend line for expected freight car loadings. (Round your intermediate calculations and final answers to 3 decimal places.)

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Examining an rf splitter and power levels

Analysing an RF splitter and power levels, A splitter is a device that has a single input and several outputs. It is used to send a signal to several different locations

  What is the equilibrium hole concentration

A Si sample is doped with 10^17 As atoms/cm^3. What is the equilibrium hole concentration P0 at T=300K?

  Find circuits approximate thevenin resistance

The open circuit voltage of the battery is 1.493 V. When a 100 resistor is connected across it, its measured voltage is 1.356V. Find its approximate Thevenin resistance and draw a model for the battery.

  How much optic power must reach the receiver

An analog system has a bandwidth of 10 MHz, a photodetector of = 0.5 A/W and ID = 1 nA, and a signal to noise ratio (SNR) of 30 dB. The receiver's temperature is 270 C and the load resistance is 50 .

  Calculate the power dissipated in the device

An InP TED is 0.5 pm long with a cross sectional area of 10" cm2 and is operated in the transit-time mode.(a) Find the minimum electron density no required for transit-time mode.

  What are the exact form of the equations

What are the exact form of the equations for the 2nd-order step response for the underdamped, critically-damped, and overdamped conditions.

  Find the density for germanium

Find the density for germanium (Ge) semiconductor atoms give that its lattice constant a-5.66Å (Angstrom) and atomic weight is 72.59 g/mole.

  Find the power being absorbed

A current source of 12 cos 2000t A, a 200-ohm resistor, and a 0.2-H inductor are in parallel. Assume steady-state conditions exist. At t = 1 ms, find the power being absorbed by the (a) resistor; (b) inductor; (c) sinusoidal source.

  Calculate the expression for the voltage

Hand calculate the expression for the voltage and current of the capacitor and plot these equations by using MATLAB and calculate the time constants of each circuit and point out this time constants at your voltage graphs.

  Write a sequence of instructions to initialize and run timer

051 Microprocessor a. Write a sequence of instructions to initialize and run the timer to geneate an 800 baud rate clock. b. what would be the baud rate if the intial value of the itimer was set to 9AH

  Compare a lumped element model of a lossless transmission

Compare a lumped element model of a lossless transmission line (single L and C) with the distributed model. Use the following values for the transmission line in this comparative analysis.

  Calculate the essential bandwidth using energy percentage

a. Plot the spectra of X(w) = t sinc(wt/2). Let t = 1 and -20 =

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd