Reference no: EM131336609
Assignment:
Using Op-Amps for Radio Frequency Design
1. Read Chapter 7 from the text.
2. Read the document- RF Oscillator.pdf: https://content.grantham.edu/at/EE332/Week_4_RF_Oscillator.pdf
3. Calculate the value of RG needed in order to produce the following output voltages (peak-to-peak):
1. Vout = 5 volts
2. Vout = 7.5 volts
3. Vout = 10 volts
4. Vout = 10.5 volts
4. Include all calculations in a Word document with the title: "HW4_StudentID", with your student id substituted in the file name. Show all work for full credit.
5. Upload file "HW4_StudentID"
Lab:
Using Op-Amps for Radio Frequency Design
The purpose of this lab is to construct a practical Colpitts RF Oscillator circuit with MultiSIM. The frequency of output waveforms will be measured using a virtual oscilloscope. Students will gain an understanding of the effects biasing resistors on the output frequency of oscillator.
1. Review the document- RF Oscillator.pdf
2. Calculate the value of RG in order to produce the following output voltages (peak-to-peak).
|
Vout
|
RG
|
|
5V
|
|
|
7V
|
|
|
10V
|
|
|
12V
|
|
|
15V
|
|
3. Construct the Colpitts Oscillator of the document in Multisim.
4. Using the values of RG from the table, run the simulations to confirm the output voltage, Vout.
5. Using Agilent Oscilloscope, plot the output waveform of Vout for each case and measure the frequency of the output. Take the screen capture for each measurement.
6. Reverse the polarity of the diodes and redo steps 4 and 5.
|
RG
|
Measured Frequency (in Hz)
|
Vout (Forward Biased)
|
Vout (Reverse Biased)
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
7. Observe the differences in the output voltage and the frequencies between forward and reverse biased diode settings and explain the significance of diodes in the operations of this oscillator.
8. Answer the following questions:
a. Describe the operations of the Colpitts oscillator circuit and explain how it helps in generating clean sinusoidal output?
b. How does the two diodes help in providing linear input to the voltage follower circuit?
c. Discuss how the resistor Ros can be setup to perform soft clipping operations.
9. Create a new word document called "Lab4_StudentID.docx" with your GID substituted into the file name.
10. Verify all calculations from analysis and measurements from simulation. Save the results along with the table and paste the screen captures in the word document. Make sure to answer the questions.
11. Upload file "Lab4_StudentID" in Blackboard.
|
Consider the role of it in the supply chain
: Consider the role of IT in the supply chain. Some of the advantages of using IT include visibility, consumer behavior, competition, and speed. Select one advantage, and describe how IT improves the supply chain by using that advantage. Include a r..
|
|
The put-call parity-would be the price of call option
: Suppose the price of a share XYZ is 100 at t=0. At t=1, the share-price either increases to 108 or decreases to 88. At t=2, the share-price will either be 120, or 96 (if the share goes up at t=1 and goes down at t=2 and if it goes down at t=1 and goe..
|
|
Determine the net annual financing cost
: DuBois Apparel Company is considering factoring its receivables.- Determine the net annual financing cost of this factoring arrangement.
|
|
Differences between rfid and nfc communication technologies
: Use the Internet to research the differences between RFID and NFC communication technologies. Then write a paper in current APA format that compares three similarities and three differences, discuss how each of these technologies can be used in pe..
|
|
Describe the operations of the colpitts oscillator circuit
: Describe the operations of the Colpitts oscillator circuit and explain how it helps in generating clean sinusoidal output? How does the two diodes help in providing linear input to the voltage follower circuit?
|
|
Determine the annual financing cost
: The additional cost of establishing a field warehouse would be $35,000 per year. Determine the annual financing cost to Clearfield under the arrangement if Clearfield borrows.
|
|
Sell the security at maximum discount
: A CFO wants to sell a security. The CFO knows the true value. She is willing to sell the security at a maximum discount of 15%. A potential investor does not know the true value but does know that the true value equals 100 with probability μ, equals ..
|
|
Prepare a business memo summarizing what you found
: Complete the tutorials in short-term and long-term financing.- Prepare a business memo summarizing what you found.
|
|
Transient analysis of the waveforms of the mos inverter
: Repeat this problem for the more difficult but realistic case in which the input gate voltage is the output from a preceding CMOS driven by a square wave.
|