Describe the difference between the two locations at time t

Assignment Help Civil Engineering
Reference no: EM13306528

The peak-hour volumes at two locations were counted and found to be equal. However, the PHFs were .85 at the first location and .60 at the second. Describe the difference between the two locations if t=5 min.

Reference no: EM13306528

Questions Cloud

Will everything eventually be ethernet / csma/cd : Is Ethernet that good that it's the predominant form of LAN? Will everything eventually be Ethernet / CSMA/CD?
Huffman coding for compression : Huffman coding for compression - Starting from the beginning of the bit sequence, convert each sequence of 8 consecutive bits into 1 byte. If the number of bits is not a multiple of 8, pad the end of the bit sequence with 0s.
Calculate distance downwind xl at which the plume released : A powerplant is burning coal on a cold, clear winter morning at 8am with a wind speed of 2.6m/s measure at 30m and an inversion layer with its base height of 697m. The effective stack height is 30m.
Calculate the maximum coefficient of performance : It is desired to build a heat pump that has an output temperature of 31 °C. Calculate the maximum coefficient of performance for the pump when the input source is ground water at 8.1 °C
Describe the difference between the two locations at time t : The peak-hour volumes at two locations were counted and found to be equal. However, the PHFs were .85 at the first location and .60 at the second. Describe the difference between the two locations if t=5 min.
How high can that person climb the ladder before the slip : A ladder is supported by a horizontal floor and a vertical wall. Is 15 feet long and weighs 50 lbs, with the weight concentrated at its midlength. The ladder supports a person weighing 180 lbs.
Determine the maximum force that acted on the shell : A boad initially stationary at water,fires a shell in i direction,The shell's air speed =822 m/s.The shell was in the gu8n for .16s, and the force exerted on the shell decrease linearly fromthe initial force to zero over the firing interval.
When will the mass first reach a turning point : The frequency of a mass attached to a spring is 4Hz. At time t = 0, the mass has an initial displacement of 0.200m, When will the mass first reach a turning point
How high would it go if there were no air resistance : A projectile of mass 0.702 kg is shot straight up with an initial speed of 16.1 m/s. How high would it go if there were no air resistance

Reviews

Write a Review

Civil Engineering Questions & Answers

  Explain how to compute the disclosure and elevation of a

Reciprocal leveling gives the following readings in feet from a setup near A: on A, 2.071; on B, 8.254, 8.259 and 8.257. At the setup near B: on B, 9.112; on A, 2.926, 2.930 and 2.927. The elevation of B is 1099.600. Compute the disclosure and ele..

  Find the degree of saturation of the sandy soil in situ

an embankment for a highway 30m wide & 1.5m in a compacted thickness is to be constructed from a sandy trucked from a borrow pit.

  Determine the sludge age and cell wastage flow rate

Assume: Suspended solids in effluent negligible Wastage is from aeration tank Yield coefficient = 0.4 Bacterial decay rate = 0.04 1/d Effluent BOD5 = 10mg/L F/M = 0.33 mg/mg*d BOD5 after primary settling = 150mg/L MLVSS = 1700mg/L MLSS = 1.4(MLVSS..

  Write a c program that calculates the factorial of numbers

Write a C program that calculates the factorial of the number from 0 to the integer N, which is not greater than 10

  Determine the angle of twist of end a with respect to b

The 800 mm diameter shaft is made of A-36 steel. If it is subjected to the uniform distributed torque of 5kN*m/m, determine the angle of twist of end A with respect to B.

  Compute departures and latitudes and linear misclosure

Compute departures and latitudes, linear misclosure, and relative precision for a five-sided, closed traverse. It is given that the aziumuth of AB is 74 degrees 31 minutes, 17 seconds, A = 105 degrees 13 minutes 14 seconds B = 92

  What average force was exerted on the ball

After falling from rest from a height of 32 m, a 0.45 kg ball rebounds upward, reaching a height of 22 m. If the contact between ball and ground lasted 1.5 ms, what average force was exerted on the ball?

  Determine what is the turbidity of the original sample

A wastewater sample was diluted by turbidity free water; 5ml was diluted to 250 ml. Turbidity of the diluted sample was 2.3 NTU, what is the turbidity of the original sample

  Calculate the mass emissions rate of ash into the atmosphere

The coal has an ash content of 12% by mass. Forty percent of the ash falls out the bottom of the furnace. The rest of the ash is carried out of the furnace with the hot gases into an electrostatic precipitator (ESP).

  How many gallons of water are contained in the tank

Develop a table that shows: 1) How many gallons of water are contained in the tank if the volume is measured in increments of 1 ft from the bottom to the top. 2) The mass of water at each increment, expressed in lbm.

  Solve given differential equation by separation of variables

Given computer-generated direction field. Then sketch, by hand, an approximate solution curve that passes through each of the indicated points. Use different colored pencils for each solution curve.

  Compose a list here of the geological terms

Was the dam itself of sound design and a product of quality construction?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd