Describe hydrogen fluoride is a highly reactive gas

Assignment Help Chemistry

Reference no: EM13226688

Hydrogen fluoride is a highly reactive gas. It has many industrial uses, but the most familiar property of HF is its ability to react with glass. As a result, HF is used to etch glass and frost the inner surfaces of light bulbs. Hydrogen fluoride must be stored in stainless steel containers, and aqueous solutions must be stored in plastic bottles. Hydrogen fluoride can be produced from H2 and F2:

H2(g) + F2(g) 2 HF(g) Keq = 115
In a particular experiment, 4.65 bar each of H2 and F2 are added to a 3.38 L flask.

A) What is the equilibrium partial pressure of H2?

Units: bar

The number of significant digits is set to 3; the tolerance is +/-5%

B) What is the equilibrium partial pressure of F2?

Units: bar

The number of significant digits is set to 3; the tolerance is +/-5%

C) What is the equilibrium partial pressure of HF?

Units: bar

The number of significant digits is set to 3; the tolerance is +/-5%

Reference no: EM13226688

Questions Cloud

Find out the heat of combustion of sucrose : A 250 g sample of sucrose C12H22O11(s) was burned in a 21.00 kg iron calorimeter immersed in 1.450 Kg of water. The initial temperature of the system was 24.32 degrees Celsius. Determine the heat of combustion of sucrose under the conditions prese..

Is this delegation of power too broad or too restrictive : Are all laws ethical? Why or why not? Provide examples of ethical and unethical laws and a statute gives the Department of the Interior the power to allow or curtail mining in the national forests "as the best interests of all users of the national..

Explain calculated equilibriumbe t constants be too high : joseph failed to calibrate the spectrophotometer. As a result, all absorbance values for the standard solutions that are measured and recorded are too high.

Calculate output resistance at differential output terminals : The IC differential amplifier is to be fabricated in a CMOS technology having the technology specifications of Kn' = 200 uA/V. Kp' = 100 uA/V. Vtn = 1V Vtp = -1V Va = 50V L = 1u. Calculate all the device widths for a constant bias current of 1mA

Describe hydrogen fluoride is a highly reactive gas : Hydrogen fluoride is a highly reactive gas. It has many industrial uses, but the most familiar property of HF is its ability to react with glass. As a result, HF is used to etch glass and frost the inner surfaces of light bulbs.

What would be the minimum sample rate needed an ekg signal : What would be the minimum sample rate needed to adequately acquire an EKG signal Note that this problem is not as simple as it appears to be, because while the fundamental frequency may be relatively low, artifacts in the EKG may be at frequencies..

Explain what is the maximum ratio compatible with atp : what is the maximum [ATP]/[ADP][Pi] ratio compatible with ATP synthesis assuming that the number of protons trans-located per ATP formed is 2, the temperature is 25C and the change of pH is 0.75?

Design circuit using only two-three and four-input nand gate : Design a circuit that will add either 1 or 2 to a 4-bit binary number N. Let the inputs N3, N2, N1, N0 represent N. The input K is a control signal. The circuit should have outputs M3, M2, M1, M0, which represent the 4-bit binary number M.

Find out the number of mols of hydrogen in the compound : the reaction produces 0.90 mol of CO2 and 0.45 mol of H2O. Determine the number of mols of carbon in the compound. Determine the number of mols of hydrogen in the compound.

User Account

All Pages