Describe befwm under steady-state conditions

Assignment Help Civil Engineering
Reference no: EM131099339

Brillouin-enhanced four-wave mixing. In addition to SBS, light beams can interact in a Brillouin medium by means of the process known as Brillouinenhanced four-wave mixing (BEFWM), which is illustrated in the following figure.

1490_daa348a7-9bb5-487f-9ac5-51d53805c9ae.png

In this process, the incoming signal wave A3 interferes with the backward-going pump wave A2 to generate an acoustic wave propagating in the forward direction. The forward-going pump wave scatters from the acoustic wave to generate the phase-conjugate wave A4. Since A4 is at the Stokes sideband of A1, it also undergoes amplification by the usual SBS process. Phase-conjugate reflectivities much larger than 100% have been observed in the BEFWM process. Using the general formalism outlined in Section 9.3, derive the form of the four coupled-amplitude equations that describe BEFWM under steady-state conditions. Solve these equations analytically in the constant-pump approximation

Reference no: EM131099339

Questions Cloud

Strategy formulation for international expansion : You have been asked by the CEO of a major Australian Bank to advise them on their strategy formulation for International expansion -  You are required to assess the attractiveness of each market and put forward recommendations for future action.
Estimate numerically the attenuation distance of light : Also, estimate numerically the attenuation distance of light in air-that is, the propagation distance through which the intensity falls to 1/e of its initial value due to scattering losses
How potential perception of dependency might contribute : An explanation of whether means-tested programs (TANF, SNAP, and SSI) create dependency. Then, explain how the potential perception of dependency might contribute to the stigma surrounding welfare programs. Finally, explain the perceptions you hav..
Run-on sentences or sentence fragments : After selecting an answer, you have the option to Save. Click Next Page to go to the next question. Click Submit after answering Question 10.
Describe befwm under steady-state conditions : Solve these equations analytically in the constant-pump approximation
Prepare a written analysis of the financial ratios : Prepare a written analysis of the financial ratios resulting from the Week 2 eVal Financial Forecast of the selected company. This must include trend analysis (historical and projected) and comparative analysis (cross-sectional or industry).
What determines the minimum value of the duration : What determines the minimum value of the duration of the output pulse
What is the minimum value of the laser pulse energy : what is the minimum value of the laser pulse energy per unit area that can be used to excite SBS? (SBS is often excited by tightly focused laser beams rather than by collimated beams to prevent optical damage to the windows of the cell
Causing the democratic party to expect electoral gains : Over the past twenty to thirty years the U.S. has experienced "political party realignment" in most states.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Estimate the probability that a given square meter

The number of flaws on a sheet of aluminum manufactured by a certain process follows a Poisson distribution. In a sample of 100m2 of aluminum, 200 flaws are counted.

  Discuss the advantages and disadvantages of 8-bit adc

Discuss the advantages and disadvantages of using 8-bit and 10-bit resolution for the analog-to-digital converter.

  How long would take layer to reach 30percent consolidation

how long would it take a layer of this clay 5m thick to reach the same degree of consolidation under the same stress and drainage conditions. how long would it take the layer to reach 30% consolidation.

  What is the current draw of the motor during the operation

The motor has an efficiency of 80%. It operates at 240V AC. A 12" diameter drum is attached to the gearbox output shaft, and a wire rope is wrapped around the drum to act as a winch. The winch is used to raise bucket of raw material in a factory.

  Check your solution by a direct differentiation with time

For an interval of motion the drum of radius b turns clockwise at a constant rate in radians per second and causes the carriage P to move to the right as the unwound length of the connecting cable is shortened.

  Design a non-air-entrained concrete mix for a small job with

Design a non-air-entrained concrete mix for a small job with a maximum gravel size of 3/4". Show the results as follows:

  Find compression of spring when car is momentarily bought

if the rolling resistance is 1/100 of the weight of the car, determine the compression of each spring when the car is momentarily brought to rest spring 1 500kN/m spring 2 300kN/m and distance between springs and car 30m

  Find the swell and shrinkage and load and shrinkage factors

material (LCY) in 12 yard dump trucks, placing it, and compacting the weight of the soil is 3,750 lb/cu.yd. (30 pts.) (show your calculations) a) Find the Swell and Shrinkage b) Load and Shrinkage Factors

  Estimate the power in watts that can be produced

An Engineer is considering the development of a small wind turbine (D=1.25m) for home applications. The design wind speed is 15 mph at T=10C and p=0.9 bar. The efficiency of the turbine is n=20% meaning that 20% of the kinetic energy in the wind can ..

  What direction should the boat have been headed to actually

To cross a river that is 1 km wide, with a current of 6km/h, a novice boatskipper holds the bow of the boat perpindicularto the far river bank, intending to cross to a point directly across the river from the launch point.

  How many barrels of oil are recoverable

How much total money do you expect if oil stays at $95 per barrel? 6. How much total money do you expect if oil stays at $30 per barrel? What will be your average monthly royalty check at $95 per barrel?

  Determine allowable moment about the horizontal neutral axis

Determine the allowable moment about the horizontal neutral axis that a timber beam with nominal size 50 X 100 can resist without exceeding the allowable stress of 10 MPa.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd