Reference no: EM13545611
1.Determine the components of displacement at 1. Take E = 200 GPa, I = 250(10^6) mm^4, A = 12(10^3) mm^2 for each member.
2.Using Buckingham-Pi method, derive a relationship to evaluate the discharge, Q, over a rectangular notch as a function of the width of notch, b, acceleration due to gravity, g, fluid density, p, dynamic viscosity, µ, depth of flow, h, and surface tension (force per unit length), r. Choose repeating variables in the following order: b, g, p,µ,h, r , Q.
|
Determine the min coefficient of static friction between
: Determine the min coefficient of static friction between tires and the road surface so that the 1.5Mg car does not slide as it travels at 80km/h on the curved road. Neglect the size of the car.
|
|
Determine the height from the ground where the two balls
: A ball is thrown with an upward velocity of 5m/s from the top of a 10-m high building. One second later another ball is thrown vertically from the ground with a velocity of 10m/s. Determine the height from the ground where the two balls pass eachothe..
|
|
How much power in unit of watts was used by the runner
: A runner weighing 150 pounds has just completed a 10-mile course in 1.25 hours. How much power, in unit of watts, was used by the runner's body?
|
|
Find the cumulative distribution function of the elongations
: Elongation (in %) of steel plates treated with aluminium are random with probability density function
|
|
Derive a relationship to evaluate the discharge
: Using Buckingham-Pi method, derive a relationship to evaluate the discharge, Q, over a rectangular notch as a function of the width of notch, b, acceleration due to gravity, g, fluid density
|
|
The circular cross section will be maintained during
: A cylindrical rod of 1040 steel originally 15.2 mm (0.60 in.) in diameter is to be cold worked by drawing; the circular cross section will be maintained during deformation
|
|
Determine the normal depth of flow before and after the
: Determine the normal depth of flow before and after the change in gradient. Will it be possible to produce a hydraulic jump in the channel downstream of the junction of two slopes?
|
|
Determine the depth of flow immediately upstream of the hump
: A rectangular channel of 2 m depth and 5 m width carries 1 m deep running water. It is laid to a slope of 0.001 with Manning’s n = 0.02. Some distance downstream there is a hump of height 0.5 m on the stream bed
|
|
The final temperature in the tank in degrees celsius
: A rigid tank whose volume is 10L is initially evacuated. A pinhole develops in the wall, and air from the surroundings at 1 bar, 25 degrees Celsius enters until the pressure in the tank becomes 1 bar.
|