Demonstrate the special properties of soils

Assignment Help Mechanical Engineering
Reference no: EM131242785

A rubber ball contains saturated sand, and water reaching into the neck of the glass tube inserted into the ball, above the sand. When squeezing the ball between two fingers, the water level appears to go down. This phenomenon, which is often used in geotechnical laboratories to demonstrate the special properties of soils, can be explained by assuming that the initial density of the sand is very high (if this not the case the sand may be densified before the demonstration by knocking the ball several times onto the table, preferably before the arrival of the spectators). The squeezing of the sand results in a shear deformation, and in this dilatant material this is accompanied by a volume expansion of the assembly of granular particles. This means that the pore volume increases, and thus water is drawn into the ball from the glass tube.

Reference no: EM131242785

Questions Cloud

Sustainability of long-term business operations : 1. How does the sustainability of long-term business operations? 2. How does the global market affect business strategy?
Constructing picks on the surface of the roller : The result will be that when the road is completed the surface deformations will remain small. The initial cost is larger, but maintenance costs will be smaller. It may be noted that the stresses near the soil surface can be further increased by c..
Bank loan request for handyman business : Write a letter to a bank requesting a loan. Your letter must be persuasive enough to convince the bank to give you a loan. Be sure to include in the letter the following:
How criminal procedure should operate : Did these Scriptures change or confirm your views about how criminal procedure should operate according to each topic?
Demonstrate the special properties of soils : The squeezing of the sand results in a shear deformation, and in this dilatant material this is accompanied by a volume expansion of the assembly of granular particles. This means that the pore volume increases, and thus water is drawn into the ba..
Discuss the reasoning behind these cases and laws : When examining the civil and criminal law, think about the objectives below to help guide you in formulating your research report. Historical makeup: Give an overview of the civil case and criminal case which helped to shape the criminal justice sy..
Computer a desirable or undesirable activity : Is monitoring an employee's work on a computer a desirable or undesirable activity from a manager's perspective? From the employees' perspective? Defend your position.
How does the media influence sport : 1. How does the media influence sport? 2. How does sport influence the media? 3. List and describe one development or improvement in sports media and/or technology over the past 20 years and briefly discuss its affect on sports.
What do the mission and vision statements communicate : What do the mission and vision statements communicate? How might the organization use mission and vision statements when establishing goals for the organization?

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  First tubes and on the tubes deep in teh array

Air at 20C flows over a very large bank of 2 cm OD tubes that are kept at 100C. the air approaces at an angle of 15 degress off normal to the tubes. the tube array is staggered, with SL= 3.5 CM and ST= 2.8 cm. Find Average h on the first tubes and on..

  Why is it often difficult to evaluate the elastic limit

Why is it often difficult to evaluate the elastic limit. What is the effect of poor alignment of the specimen. Why does a specimen that is properly aligned provide a more accurate estimate of the tensile strength compared to the estimate provided f..

  If the parameters are the depth d of the friction layer the

consider the case of a knife whose leading edge is the z-axis and the blade covers the half plane defined by x 0.

  Determine the total amount of heat which must be added or

carbon monoxide and water vapor react in stoichiometric amounts to form carbon dioxide and hydrogen.the feed enters at

  Calculate the maximum tensile stress st

For the position shown in the figure, determine the orientation of the neutral axis and calculate the maximum tensile stress σt and maximum compressive stress σc in the beam. Assume that θ= 30° and M = 30 k-in.

  Also venous blood enters at 0 mm hg and leaves at 15 mm hg

imagine that the heart acts as a pump. blood enters the heart from the lungs at 6mm hg and leaves to the rest of the

  Determine the mass flow rate of condenser cooling water in

water is the working fluid in an ideal regenerative rankine cycle with one open feedwaer heater. superheated vapor

  Consider x norm57 y norm57 and z norm19 and assume xy

consider x norm57 y norm57 and z norm19 and assume xy and z are independent.1 find and sketch the probability

  Expression for frictional dissipation and friction factor

For a laminar flow between two parallel plates shown figure below, obtain an expression for the pressure drop and velocity profile. Also, obtain an expression for Frictional dissipation and the friction factor.

  Calculate the heat transfer from the plate assuming plate

air at 68 degrees f and 1atm. flows over a flat plate at 114.8 fts. the plate is 29.5 in long and 12 in wide. the plate

  Determine the balanced reaction equation

Determine the balanced reaction equation. For the CO and SO2, determine the amount, in kmol per 106 kmol of combustion products (that  is, the  amount in parts per million).

  The atomic radii of a divalent cation and a monovalent anion

The atomic radii of a divalent cation and a monovalent anion are 0.77 nm and 0.136 nm, respectively. Calculate the force of attraction between these two ions at their equilibrium interionic separation.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd