Delinquency prevention program is being established

Assignment Help Civil Engineering
Reference no: EM13551325

Answer the following question in a short position paper (500 to 1000 words, which with a typical font and spacing will be 2 to 4 pages), complete with citations:

A new after-school delinquency prevention program is being established. The Program Director calls you up on the telephone and asks your advice on how to design a good program. What advice can you give her?

Reference no: EM13551325

Questions Cloud

Explain the freezing point of a solution that contains : What is the freezing point of a solution that contains 12.0 g of glucose (C6H12O6) in 50.0 g of water (Kf = 1.86°C/m)
Determine the average normal stress in the links : Determine the average normal stress in the links
What is the rotational kinetic energy of smaller cylinder : Two uniform solid cylinders each rotating about its central(longitudinal) axis, have the same mass of 4.92 kg and rotate with the same angular speed of 118rad/s, but they differ in radius
Find the equilibria of the system : Find the equilibria of the system and sketch the direction field for the system - Parameter values obtained from the Beth Israel Deaconess Medical Center.
Delinquency prevention program is being established : A new after-school delinquency prevention program is being established. The Program Director calls you up on the telephone and asks your advice on how to design a good program. What advice can you give her?
Explain what is the change in volume of the balloon : The balloon then rises to an altitude of 6000 ft, when the pressure is 605 torr and the temperature is 15 °C. What is the change in volume of the balloon as it ascends from sea level to 6000 ft
Evaluate the force exerted by the horizontal rope : A 55.1-kg ice skater is moving at 3.99 m/s when she grabs the loose end of a rope, the opposite end of which is tied to a pole. Determine the force exerted by the horizontal rope on her arms
Round up yellow and all-red times to the nearest ½ second : Determine the appropriate yellow and all-red interval to use for each phase. Assume a 10 ft/sec2 deceleration rate, a one second reaction time, and a 20 ft. vehicle length. Round up yellow and all-red times to the nearest ½ second.
In carbon-nitrogen nuclear fusion cycle : In carbon-nitrogen nuclear fusion cycle, protons are fused to form a helium nucleus. Positrons releases some energy. The number of protons fused and the number of positrons released in this process respectively are

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine whether the environmentalists case is justified

If the forest is considered to be negatively affected at levels exceeding 300 ?g m-3, use your knowledge of atmospheric transport to determine whether the environmentalists' case is justified.

  Calculate the head loss with a roughness height

A galvanized iron pipe with a roughness height (e) of 5x10-6 m with a diameter (D) of 0.05 m and a length (L) of 100 m carries a discharge (Q) of 0.003 m3/s. Calculate the head loss (hL).

  Determine the angle theta for equilibrium from two springs

The 10-lb lamp fixture is suspended from two springs, each having an unstretcfhed length of 4 ft and stiffness of k=5lb/ft. Determine the angle theta for equilibrium.

  How much calcium and or magnesium should be removed by the

The given groundwater shows the following chemical composition: Sodium =7 mgIL, Calcium = 70 mg/L, Magnesium = 35 mg/L, Potassium = 1 mgIL Bicarbonate = 200 mg/L, Sulfate = 30 mgIL, pH = 7.5 Atomic mass unit: sodium (23), calcium (40), magnesium (24...

  Calculate the quality of the steam exiting heat exchanger

A chemical plant uses a tube-­within-­a-­tube counterflow heat exchanger to heat air with the use of steam. During steady state operation, the air flows into the exchanger at a rate of 5,000 kg/h and a temperature of 27C and exits at a temperature..

  What is the thickness of the viscous sublayer

The influent BOD5to a primary settling tank is 345 mg/L.The average flow rate is 0.050 m3/s.If the BOD5 removal efficiency is 30%,How many kg of BOD5 are removed in the primary settling tank each day?

  Determine the side slopes of a suppressed trapezoidal sharp

Determine the side slopes (i.e. 1:3, etc.) of a suppressed (n=0) trapezoidal sharp crested weir with width B and upstream head H so that the discharge through it is the same as that through a rectangular sharp crested

  What will be time-mean speed and space-mean speed for stream

Assume you are an observer standing at a point along a three-lane roadway. All vehicles in lane 1 are travelling at 30 mi/h, all vehicles in lane 2 are travelling at 45 mi/h, and all vehicles in lane 3 are travelling at 60 mi/h

  Design a rectangular section for cantilever beam that spans

Roe is the ratio of nonprestressed reinforcement in a section, and roe balanced is the ratio of tensile reinforcing producing balanced strain condition. Show cross sections, including bar sizes, arrangements, and spacing.

  How far apart must two 18 m diameter tanks be placed

How far apart must two 18 m diameter tanks be placed such that their stress overlap is not greater than 10% of the contact stress at depths of 10, 20, and 30 m

  Determine the total amount of heat required when its done

10-kg of nitrogen is heated from 20 degrees C to 250 degress C. Determine the total amount of heat required when this is done in (a) a constant-volume process and (b) an isobaric process.

  Determine the plane strain fracture toughness of the polymer

A polymer that contains internal flaws 1.5 mm in length fails at a stress of 30 MPa. Determine the plane strain fracture toughness of the polymer. Assume a polymer specimen of "infinite" width.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd