Reference no: EM13886221
1. Define Vapour pressure
2. What is Compressibility?
3. Define Surface Tension.
4. List the instruments works on the basis of Bernoulli's equation.
5. State the assumptions used in deriving Bernoulli's equation
6. Define Boundary layer Thickness.
7. Mention the range of Reynold's number for laminar and turbulent flow in a pipe.
8. Give the expression for the coefficient of friction in viscous flow?
9. State Darcy-Weisbach equation
10. State Buckingham's p theorem.
11. Define kinematic similarities
12. How are fluid machines classified?
13. What is meant by Priming?
14. Why are centrifugal pumps used sometimes in series and sometimes in parallel?
15. What is indicator diagram?
|
Give two examples of orthogonal cutting
: 1. Give two examples of orthogonal cutting. 2. Define tool life 3. Define heat engine. 4. What is crank shaft? 5. Define refrigeration. 6. What is meant by air conditioning?
|
|
Find the average shear stress acting on the channel walls
: Water flows at a depth of 80 cm in an open channel on a slope of 0.0012. Find the average shear stress acting on the channel walls if the channel cross section is a 140-cm-wide rectangle
|
|
How is the u.s. economy different from a command economy?
: How is the U.S. economy different from a command economy?
|
|
Define the term compression ratio
: 1. Define the term compression ratio. 2. What are the assumptions made for air standard cycle?
|
|
Define vapour pressure
: 1. Define Vapour pressure 2. What is Compressibility? 3. Define Surface Tension. 4. List the instruments works on the basis of Bernoulli's equation. 5. State the assumptions used in deriving Bernoulli's equation 6. Define Boundary layer Thickness.
|
|
What are your team recommendations
: What are your team recommendations? Should there be something installed at this location? If so, which and why that choice? If not, then why not
|
|
Explain the term reversibility
: 1) Explain the term reversibility. 2) Write the two property equations involving entropy. 3) What is meant by compressibility factor? 4) What is meant by partial molar property?
|
|
Is the check a bearer instrument or an order instrument
: Is the check a bearer instrument or an order instrument? Did Glenn's delivery of the check to Carol constitute a valid negotiation? Why or why not? What type of instrument did Carol make after endorsing the check
|
|
Estimate the power output of the turbine
: A 90% efficient turbine operates between two reservoirs connected by a 200-m length of 40-cm-diameter cast iron pipe that transports 0.8 m3=s of 20-C water. Estimate the power output of the turbine if the elevation difference between the surfaces ..
|