Define the total molarity of acid and conjugate base

Assignment Help Chemistry
Reference no: EM13318312

A beaker with 170 mL of an acetic acid buffer with a pH of 5.000 is sitting on a benchtop. The total molarity of acid and conjugate base in this buffer is 0.100 M. A student adds 8.70 mL of a 0.370 M HCl solution to the beaker. How much will the pH change? The pKa of acetic acid is 4.760.

Reference no: EM13318312

Questions Cloud

What acceleration does the wagon have : A boy pulls with a force of 20 N on the 300 N wagon. What acceleration does the wagon have
Explain what is the maximum number of moles a gas : A 3.00L container is rated to hold gas at a pressure no greater than 100atm. Assuming the gas law behaves ideally, what is the maximum number of moles a gas that this vessel can hold at 27 degrees C
Calculate the maximum bending stress produced in the pole : A Timber power-line pole is 10 in. in diameter at its base where it is solidly embedded in concrete. The pole extends 20 ft vertically upward from its base and is subjected to a horizontal pull of 300 lb at its top.
What is the speed and direction of motion of the ball : A golfer hits a ball from the origin with an initial speed of 30.0m/s at an angle of 50 degrees above the horizontal. what is the speed and direction of motion of the ball just before it lands
Define the total molarity of acid and conjugate base : A beaker with 170 mL of an acetic acid buffer with a pH of 5.000 is sitting on a benchtop. The total molarity of acid and conjugate base in this buffer is 0.100 M. A student adds 8.70 mL of a 0.370 M HCl solution to the beaker.
Indicate the gains to zambia : State the commodity in which each country has absolute advantage and identify the commodity of comparative advantage for each country and indicate the gains to Zambia and Tanzania if the two countries exchanged 6 barrels of oil for 6 yards of cloth.
Calculate the maximum shear force v that a flange is capable : If the allowable shear stress is 100 MPa, calculate the maximum shear force V that a W460 X 60 structural steel wide flange is capable of resisting. Use the average web shear approach.
What is the speed of the blood flow : the flow rate of blood through a 2.10x10^-6 m radius capillary is 4.07x10^-9 cm^3/s. what is the speed of the blood flow
Has the increased cost of gasoline changed your behavior : The current gasoline prices are likely to have a large impact on consumer spending but a much smaller impact on the amount of gasoline purchased. Instead, the effect is likely to be felt in other areas of spending (e.g., vacations, entertainment, ele..

Reviews

Write a Review

Chemistry Questions & Answers

  Explain frequency of an absorption spectroscopy line

Harmonic Function Morse Function Lennard Jones Function How do I determine the frequency of an absorption spectroscopy line

  Explain the heat capacity of the bomb calorimeter

When 1.550 g of liquid hexane (C6H14) undergoes combustion in a bomb calorimeter, the temperature rises from 25.87 ºC to 38.13 ºC. Find ?E rxn for the reaction in kJ/mol hexane. The heat capacity of the bomb calorimeter, determined in a separate e..

  Explain what is the concentration of n2o after 3 half-lives

For the first-order reaction, 2N2O---> 2N2 + O2, what is the concentration of N2O after 3 half-lives if 0.15 mol of N2) is initally placeed into in a 1.00-L reaction vessel

  Explain the hydrogen atom during the electronic transition

Consider the electronic transition from n = 2 to n = 4 in a hydrogen atom and select the correct statement below.

  How many milliliters of 0.54m hcl solution are needed

how many milliliters of 0.54M HCL solution are needed to react completely with 4.6g of zinc to form zinc (II) chloride?

  Explain what is the ph of a solution of 0.450 m kh2po4

What is the pH of a solution of 0.700 M K2HO4, potassium hydrogen phosphate? b)What is the pH of a solution of 0.450 M KH2PO4, potassium dihydrogen phosphate

  Compute the molar solubility of agcl

Calculate the molar solubility of AgCl in a solution made by dissolving 10.0 g of CaCl2 in 1.00 L of solution.

  Determine the initial pressure of nitrogen

2.00 L of H2 at a pressure of 368 torr and 1.00 L of N2 at an unknown pressure. If the total pressure in the flasks is 336 torr after the stopcock is opened.

  Explain the production capacity for acrylonitrile

The production capacity for acrylonitrile (C3H3N) in the United States is over 2 billion pounds per year. Acrylonitrile, the building block for polyacrylonitrile fibers and a variety of plastics, is produced from a gaseous propylene, ammonia, and ..

  Explain what volume is the micropipette set to deliver

bring 5ml of bromophenol blue to your work station. obtain a P20 Pipetman and record below the digits you see in the window on the side. What volume is the micropipette set to deliver

  How many ml of the drug should the patient receive

A patient weighs 165 pounds and is to receive a drug at a dosage of 45.0 mg per kg of body weight. The drug is supplied as a solution that contains 25 mg of drug per mL of solution. How many mL of the drug should the patient receive?

  Determine the volume of the balloon

Suppose 108.3 g of hydrogen peroxide decomposes and all of the oxygen gas is collected in a balloon at 1.00 atm and 25oC. Determine the volume of the balloon.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd