Dascribe what operation must be performed

Assignment Help Electrical Engineering
Reference no: EM13292886

Given the 16-bit value 1010 0101 1001 1000, what operation must be performed, and what operand is needed, in order to
(a) set the most significant 8 bits to 1s?
(b) clear the bits in even positions (the left most bit is 15 andthe right most bit is 0) to 0?
(c) complement the bits in odd positions?

Reference no: EM13292886

Questions Cloud

Determine what is the maximum number of carrier frequencies : what is the maximum number of carrier frequencies that would ever be needed so that any arbitrarily partitioned region would never have two adjoining cells that use the same frequency
Explain an atom of element number electronic state : An atom of element number 33 (As) is in its ground electronic state. Which one of the following sets of quantum numbers could not apply to any of its electrons
Evaluate a patients intake and expenditure : Evaluate a patient’s intake & expenditure. Determine energy balance. Evaluate factors that influence lifestyle behaviors. Provide recommendations that promote healthy lifestyle changes.
Design a non-inverting op-amp with a bandwidth : Design a non-inverting op-amp with a bandwidth of 20kHz whose open-loop gain is 100,000 and unity gain frequency of 1 MHz. Draw the Voltage Transfer Characteristic (VTC) of the designed op-amp if the power supply produces ±10V.
Dascribe what operation must be performed : Given the 16-bit value 1010 0101 1001 1000, what operation must be performed, and what operand is needed, in order to (a) set the most significant 8 bits to 1s (b) clear the bits in even positions (the left most bit is 15 andthe right most bit is 0) ..
Enzyme binds more tightly to the transition state : Prove the hypothesis: If the enzyme binds more tightly to the transition state than to the substrate, then the substrate will turn into the transition state more rapidly when it is bound to the enzyme than when it is not bound.
Why are the two costs of equity so different : A stock's last dividend was $0.80 and dividends grow at 5%; the stock's price is $61. In addition, the stock's beta is 1.50, the risk free rate is 5.5%, and the return on the market is 12%.
Which step of writing process are you currently working : Which step of the writing process are you currently working on? Describe your technique up to this point. What has worked well for you? What will you change while working on your next draft? Can we (your classmates and I) offer any assistance?
Explain convention of arbitrarily assigning a zero enthalpy : The convention of arbitrarily assigning a zero enthalpy value to all the most stable elements in the standards state and (usually) 298 K is a convenient way of dealing with the enthalpy changes of chemical processes.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the total force f-not field on the charge a

Consider 4 point charges of 10nC each located at A(1,0,0), B(-1,0,0), C(0,1,0) and D (0,-1,0) in free space. Find the total force F(not field) on the charge A.

  What types of the electrical connections in the circle

1.Name and characterize the main source working regimes and write down working regime conditions. 2.Write down the electrical source efficiency factor expression using the parameters of the source and consumer.

  What is the logic function implemented by the circuit

Consider the circuit in Figure P16.73. (a) Determine the value of Y for I†=2.5V and (i) A=B=0; (ii) A=0, B=2.5V; (iii) A=2.5V, B=0;and(iv) A=B=2.5V.(b)Repeatpart(a)forφ=0.(c)Whatis the logic function implemented by the circuit

  Determine the impulse resonpse of the fourier transform

Determine the impulse resonpse of the Fourier Transform for a moving average filter which produces the average value of the present and previous nine samples of a signal, i.e. averaged over ten samples

  Calculate the frequency response of the system at 25 hz

The transfer function of a discrete time system is given by H H(z) = z/(z-0.5) The system has a sampling rate of 100 Hz. Calculate the frequency response of the system at 25 Hz input frequency as a complex number in both rectangular and polar f..

  Derive term including source match error correction formula

Derive the two-term including source match error correction formula. Note: For all of these derivations, you should identify your standards {match, short, open} but DO NOT assume anything about their values.

  Give difference between vin n vo in voltage clipping circuit

1) What is the difference between Vin and Vo in a voltage clipping circuit with a zener diode 2) Does Vzo of a zener depend on the temperature of the surrpunding  3) Why is it necessary to put a resistor in a voltage regulator cirucit with a zener di..

  Calculate m when signals maximum p-p value raises

A 2-MHz carrier is modulated by a music signal that has frequency components from 20 Hz to 8 kHz. Determine the range of frequencies generated for the upper and lower sidebands of AM signal.

  What fundamental law requires that electrons and holes

1) What does an electron in the valence band need to go to the conduction band in a direct bandgap material 2) Si and C are both elements in Group IV ogf the periodic table. What property makes one a semiconductor and the other an insulator

  Why are overmodulated and carrier suppressed am signals

Why are overmodulated and carrier suppressed AM signals a problem from the standpoint of the receiver. Why (in what siuations) might DSB-SC be prefered over standard AM.

  Compute the power loss in transmission line with resistance

write a program to compute the power loss in a transmission line with a resistance of .05ohms/mile. compute the power loss if 500kw of power is transmitted from a power generating station to cities at distances of 20, 30, 40, 50,...100 miles at 10..

  Explain is the ideal low-pass filtering bibo stable

An Ideal Low Pass Filter: The impulse response of an ideal low-pass filter is h(t) = sin(t)/t (or the sinc signal). (a) Given that the impulse response is the response of the system to an input x(t) = f(t)with zero initial conditions

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd