Create a new mbed c-code project called intcount1

Assignment Help Electrical Engineering

Reference no: EM13277201

Create a new mBed C-Code project called IntCount1 that repeatedly counts the number of falling edge interrupts on mBed module Pin 5 (p5) during a two second interval. Use the Timeout class to provide a two second delay. During the delay, display the number of interrupts that are occurring on Pin 5 using LED1-LED4. LED1 is the low-order bit. Use only the BusOut class for driving the LEDs. Using the Timeout "attach" function, create a subroutine that Timeout will call at the end of the two second interval. At the end of the two second interval, the subroutine will use the USB serial port to output the number of interrupts seen by displaying, "Total Ints = xx", where xx is the quantity of interrupts occurring in the two second interval. Assuming the interrupts were caused by a rotating shaft equipped with a sensor, the subroutine will compute the number of Revolutions per Minute (RPMs) represented by the total interrupts seen during the two second interval. Display the RPM value on the next line with RPMs = yyy", where yyy is the computed RPM value. The LEDs should be cleared before the

next interval starts. Using "wait", provide a one second delay prior to clearing the LEDs and starting the next two second interval. The program should run "forever".

Reference no: EM13277201

Questions Cloud

Determine the size of n-channel transistors : A differential amplifier has an input gain of 3, a total pull down current of 1 mAmp, and a p-channel transistor equivalent resistance of 2K ohms. Determine the size of n-channel transistors.

Calculate the total electric flux through the given plane : Two point charges q = 97.0 nC and q = -97.0 nC are in vacuum located on the x axis at - 17.0 cm, calculate the total electric flux through the y-z plane

Explain the same concentration with different ka values : If you compare two acids of the same concentration with different Ka values. Which acid solution should have the lower pH value

Complete the anova summary table : Complete the ANOVA summary table and perform post hoc comparisons, if necessary and what conclusions can be drawn from the F-ratio and the post hoc comparisons?

Create a new mbed c-code project called intcount1 : Use the Timeout class to provide a two second delay. During the delay, display the number of interrupts that are occurring on Pin 5 using LED1-LED4. LED1 is the low-order bit. Use only the BusOut class for driving the LEDs.

Community efforts and managing public relations : Community Efforts and Managing Public Relatios

Explain the heat of combustion of benzene : Liquid benzene, C6H6, (density = 0.877 g/mL) can be used as a fuel. What is ?H in kJ for the combustion of 2.86 L of benzene producing CO2(g) and H2O. Assume that the heat of combustion of benzene is -4.18 x 103 kJ/mol.

What is the maximum weight that the wire can support : A 3.6 m long steel wire has a cross-section area of 0.047 cm2. Its proportional limit has a value of 0.0015 times its Young's modulus, What is the maximum weight that the wire can support

Determine the voltage and the current across the inductor : A 10 H inductor is connected in series with a 1.0k(ohm) resistor and a switch which closes at t=0s, Determine the voltage across the inductor and the current through the inductor for t>0 if the inductor has an initial current of 10 A.

User Account

All Pages